CONNECTION DIAGRAM: COMMANDER 400 S & W, CLASSIC ll, lll, lllD, 300D, 300G,
350A &
ENGINE WELDER WITH 115 VAC AUXILIARY
14 PIN AMPHENOL
WARNING
ELECTRIC
SHOCK
CAN KILL
Turn off input power to the Welding Power Source using the disconnect switch at the fuse box Before connecting the wire feeder.
Only qualified persons should install, use or service this machine.
N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND THE DUTY CYCLE OF IMMEDIATE AND FUTURE
APPLICATIONS. SEE
N.B. IF ONLY ONE
– 28 –
21
+ | N.D. | |
CV- | ||
| ||
| N.C. |
N.A.
9 CONDUCTOR ADAPTER CABLE
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| ||||
| FEEDER "A" |
|
| FEEDER "B" |
| ||||||
602 | 604 | 75 | 76 | 77 | 521 | 602 | 604 | 75 | 76 | 77 | 521 |
N.C. REMOTE VOLTAGE SENSING LEAD TO BE EXTENDED BY CUSTOMER DIRECTLY TO WORK USING #12 OR LARGER RUBBER COVERED FLEX WIRE. WRAP WIRE AROUND WORK LEAD AND TAPE.
N.D. BOLT AND TAPE CONNECTION.
N.E. MOUNT ADAPTER IN A CONVENIENT
LOCATION - AS NOT TO INTERFERE
WITH THE NORMAL MACHINE OPERATION.
CAUTION: WHEN MOUNTING ADAPTER TO WELDER, SPECIAL CARE IS TO BE TAKEN AS NOT TO DAMAGE ANY MACHINE COMPONENTS, SUCH AS/BUT NOT LIMITED TO ELECTRICAL COMPONENTS, WIRES OR FUEL TANKS.
N.B.
WORK
ELECTRODE | WIRE FEEDER "A" | ELECTRODE | WIRE FEEDER "B" |
M17323
NOTE: This diagram is for reference only. It may not be accurate for all machines covered by this manual. The specific diagram for a particular code is pasted inside the machine on one of the enclosure panels. If the diagram is illegible, write to the Service Department for a replacement. Give the equipment code number.