TC2 204060 Series BattChg Owners Guide.book Page 50 Friday, July 8, 2011 11:44 AM
Troubleshooting
In the event that you have a problem with your Truecharge2 Battery Charger, the following tables will help you to identify the problem and offer possible solutions to the problem.
Symptom
Indicator LEDs do not illuminate when charger is connected to an AC power source.
Symptom
The initial power up display test is not performed upon connection of battery or batteries.
Possible Cause | Solution |
| Possible Cause | Solution | |
|
|
|
|
| |
No power at AC source | Ensure that power is available at |
| Truecharge2 Battery Charger | Check quality of battery connection and | |
| charger AC input and it is within |
| does not detect battery for one of | wires. | |
| acceptable range. |
| the following reasons: | Ensure correct polarity (negative | |
|
|
| • | poor connection | connected to negative, positive |
Defective AC wiring or | Wiring must be inspected and replaced |
| • | reverse polarity connection | connected to positive). |
switches/breakers | by a qualified installer. |
|
| (blown fuse) | In case there is an accompanying fault, |
|
|
| • | damaged wiring | check the type of fault from |
Remote panel has been used to | Press the On/Standby button on the |
| • open DC breaker or external | “Interpreting Fault and Warning | |
put the charger into Standby | remote panel to turn the charger on. |
|
| fuse | Indicators” on page 43. |
mode. |
|
| • battery voltage is below 9 V |
| |
|
|
|
|
|
|
|
| 50 |
|
| Truecharge2 Series Battery Charger Owner’s Guide |
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|