Bryant 581C024--060, 581B036--072 installation instructions Ofm

581B,C
NOTES:
1.	If any of the original wire furnished must be replaced, it must
	be replaced with type 90 C wire or its equivalent.
2.	Three phase motors are protected under primary	single

phasing conditions.

3. Use copper conductors only.

4. TRAN is wired for 230 v unit. If unit is to be run with 208 v power supply, disconnect BLK wire from 230 v tap (ORN) and connect to 208 v tap (RED). Insulate end of 230 v tap.

LEGEND

C	— Contactor, Compressor		OFM	— Outdoor (Condenser) Fan Motor
CAP	— Capacitor		OLR	— Overload Relay
CLO	— Compressor Lockout		P	— Plug
COMP	— Compressor Motor		PL	— Plug Assembly
EQUIP	— Equipment		QT	— Quadruple Terminal
FPT	— Freeze Up Protection Thermostat		RS	— Rollout Switch
FU	— Fuse		SAT	— Supply Air Temperature Sensor
GND	— Ground		TRAN	— Transformer
HPS	— High-Pressure Switch			Field Splice
HS	— Hall-Effect Sensor
I	—	Ignitor		Marked Wire
IDM	— Induced-Draft Motor
IFC	—	Indoor Fan Contactor		Terminal (Marked)
IFM	—	Indoor Fan Motor
IGC	— Integrated Gas Unit Controller			Terminal (Unmarked)
LPS	— Low-Pressure Switch
LS	— Limit Switch			Terminal Block
MGV	— Main Gas Valve

Splice

Splice (Marked)

Factory Wiring Field Control Wiring Field Power Wiring

Accessory or Optional Wiring

To indicate common potential only; not to represent wiring.

C06147

Fig. 66 ---Typical Wiring Schematic and Component Arrangement (208/230-3-60 Shown)

54