Multiquip Sp-6065 operation manual Installing the Blade

Page 23

Installing the Blade

The blade can be mounted on either side of the saw to accommodate different

cutting jobs.

1.Raise the saw so that the blade will clear the ground when installed.

2.Verify that blade collars are clean and undamaged.

3.Insert the bushing and mounting bolt through the outer collar and blade.

♦Align collar pin through the blade into the inner collar.

4.Tighten the 5/8” mounting bolt to 125-175foot-poundsof torque.

♦The blade-mounting bolt on the right side of the saw (as viewed from the operator’s position) has a left hand-thread, while the blade-mounting bolt on the left side of the saw has a right-hand thread.

Blade Guard

Mounting Clip

Outer Collar with Pin

Collar

Bushing

Mounting

Bolt

Inner Collar

Tapered Blade Shaft

Fig. 5 — Installing the Blade

23

Image 23

Contents SP-6065 Concrete Saw For Help & Information Contact Multiquip Conventions California Proposition 65 Warning Table of Contents Specifications Safety Hazard Symbols Rotating Blades Skin Injection Hazard Rules for Safe Operation General Safety WarningsPage General Safety Precautions Blade Safety SAW Transportation Safety Machine Operation and Safety Decals Model no SPEC. no Serial no Serial TagSerial TAG Before Starting OperationBlade Shaft Ratios Engine Power, Cutting Power & Sheave Size18600 Blade RPM vs. Surface Feet Per Minute Sfpm Installing the Blade Installing the BladeBlade Stacking Stacking Blades for Wide CutsInstalling the Blade Guard Installing and Removing the Blade GuardBlade Guard Water Supply Collar Guard, Installed Installing the Collar GuardWater Supply System Water Supply and ControlON-OFF Control PanelHandlebar Positions Similar to illustration HandlebarsFuel System Fueling the SawStarting and Stopping the Engine ON/OFF Switch, Choke, Throttle LocationsDraining the Water System Pointer AdjustmentBlock Heaters Pointer Adjustment Raise Lower Controls Setting the Depth IndicatorSetting the Depth Stop Drive System Controls Drive SystemTransaxle TransaxleTie-downs Night LightTransportation Tie-downs and Lift Point Lift Point Lift PointRemovable Guards and Access Panels MaintenanceBelt Tension Belts and PulleysEngine Mount Lock Bolts Adjusting Blade Shaft Drive Belt TensionReplacing the Jackshaft Belt Replacing the Blade Shaft BeltDo not OVER-TIGHTEN Rotary Belt TensionerBlade Shaft Replacement Blade Shaft MaintenanceRemoving the Inner Blade Collar Blade Collar Removal/InstallationInstalling the Inner Blade Collar Installing the Inner Blade CollarInner Collar Blade Shaft Circuit Breakers Maximum Cut Depth AdjustmentLubrication Engine Air and Oil Filter ChartAttaching the PTO Bearing Puller to the Drive Plate Assembly PTO Drive MaintenanceRe-Assembling the PTO Drive PTO Drive Sheave/Bearing AssemblyRotate Engine Forward to Remove the Battery Replacing the BatteryRaise-Lower System Raise/Lower TroubleshootingJoystick Adjustment Joystick Tension AdjustmentRoutine Maintenance Hydraulic System MaintenanceTo drain the hydraulic system Draining & Filling the Hydraulic SystemTo fill the hydraulic system with oil Bleeding the Depth Stop Cylinder Bleeding the Depth Stop CylinderDrive Wheel Alignment Drive Wheel AlignmentPivot Side Adjustment Side Specifications Dimensions and Weights Www multiquip.com