Multiquip Sp-6065 operation manual Specifications

SPECIFICATIONS

Engine	57 HP Turbocharged Deutz Diesel, direct injection, air/oil cooling, oil filter and
	above-frame remote oil drain.
Engine Air Cleaner	4-Stage air filtration, pre-cleaner plus cartridge element and safety element.
Fuel Tank	10 Gallon clear-molded plastic fuel tank with sight gauge, central drain and
	shutoff valve.
Blade Shaft Assembly	Fully enclosed bearings and shaft, oil bath lubrication, 2-3/8” diameter shaft,
	magnetic drain plug, seal protectors and protected remote oil fill and vent.
Blade Collars	Plated quick-disconnect, taper lock attachment, 5.5” diam., 24 water spray ports.
Blade Flushing	Minimum water usage system, evenly distributed across the blade, panel-
	mounted flow control.
Blade Range	14” to 36”.
Max Cut Depth	15”.
Blade Guard	Extra heavy design, slip-on type with double lip seal and quick disconnect water
	hose, two handles.
Blade Shaft Drive Belt	Dual 5--Groove 3VX530 Powerband.
Blade Control	12-Volt hydraulic raise/lower system, 3 blade plunge speeds, fast and slow blade
	plunge speed buttons on joystick, raise button on joystick, one-hand control.
Blade Depth Stop	Positive, heavy-duty hydraulically controlled depth stop.
Balance	Front steer.
Handlebars	3-Position adjustable angle, storage position, quick locks.
Front Wheels	8” x 3”, precision sealed bearings in each wheel with extra end seals and seal
	protectors, no grease points.
Rear Wheels	12” x 3”.
Drive System	Hydrostatic powered transaxle with infinite speed control, joystick control, remote
	oil filter and up to 300 feet per minute travel speed. Locked axle drive.
Engine Controls	Twist-lock throttle, backlit tachometer with hour meter, voltmeter, oil pressure
	gauge and 3-position ignition switch.
Battery	12-Volt, group 75, 1000 cold cranking amps.
Front Pointer	Heavy gauge steel, 6” pointer wheel and plastic-coated tether.
Rear Pointer	Standard, adjustable.
Hardware	Grade 8 fasteners throughout.
Tools	15/16” Blade wrench.
Dimensions	L= 47-1/2” with handlebars stored, W = 32” w/o blade collars, H= 44” with front
	pointer up.
Weight	Approx. 1,500 Pounds, with oil but no fuel. (Actual weight depends on blade
	guard used.)
Serviceability	Spin-on oil filters, lubrication points, lube every 50 hours.

64