Multiquip Sp-6065 operation manual Raise Lower Controls, Setting the Depth Indicator

Raise — Lower Controls

This saw uses a 12-volt hydraulic pump and cylinder to raise and lower the

blade. The SP 6065 saw has a plunge button and a raise button. Controls are

located on the joystick handle.

Fig. 16 — Joystick Handle - Controls

1.To lower the blade to the cut, push the button on the end of the handle (1).

2.To lift the blade, hold down the Raise button on the side of the handle (3).

See the Maintenance section of this manual for an illustration of the Raise-Lower

System components, and troubleshooting techniques.

Setting the Depth Indicator

1.Lower the blade until it just touches the cutting surface.

2.Set the Depth Indicator dial to zero. (The Depth Indicator now accurately indicates how deep the blade is cutting.)

35