Multiquip Sp-6065 Installing and Removing the Blade Guard, Installing the Blade Guard

Page 25

Installing and Removing the Blade Guard

Blade Guards are “ambidextrous” – that is, they can be installed on either side of

the saw.

Installing the Blade Guard

1.Slide the Blade Guard Mounting Clip onto the Guard Mounting Tab on the frame.

2.Connect the water delivery hose to the Blade Guard.

♦Ensure that the water pipes are pointed toward the water distribution grooves in the Blade Collars.

3.Make sure the front-hinged section of the Blade Guard is fully closed before use.

Water

Delivery

Hose

Water

Distribution

Manifold

Rear Handle

Top Handle

Blade Guard hinged front

Mounting Clip

Blade Guard rear section

Fig. 7 — The Blade Guard installed (Similar to illustration)

25

Image 25

Contents SP-6065 Concrete Saw For Help & Information Contact Multiquip Conventions California Proposition 65 Warning Table of Contents Specifications Safety Hazard Symbols Rotating Blades Skin Injection Hazard Rules for Safe Operation General Safety WarningsPage General Safety Precautions Blade Safety SAW Transportation Safety Machine Operation and Safety Decals Model no SPEC. no Serial no Serial TagSerial TAG Before Starting OperationBlade Shaft Ratios Engine Power, Cutting Power & Sheave Size18600 Blade RPM vs. Surface Feet Per Minute Sfpm Installing the Blade Installing the BladeBlade Stacking Stacking Blades for Wide CutsInstalling the Blade Guard Installing and Removing the Blade GuardBlade Guard Water Supply Collar Guard, Installed Installing the Collar GuardWater Supply System Water Supply and ControlON-OFF Control PanelHandlebar Positions Similar to illustration HandlebarsFuel System Fueling the SawStarting and Stopping the Engine ON/OFF Switch, Choke, Throttle LocationsBlock Heaters Pointer AdjustmentDraining the Water System Pointer Adjustment Raise Lower Controls Setting the Depth IndicatorSetting the Depth Stop Drive System Controls Drive SystemTransaxle TransaxleTransportation Tie-downs and Lift Point Night LightTie-downs Lift Point Lift PointRemovable Guards and Access Panels MaintenanceBelt Tension Belts and PulleysEngine Mount Lock Bolts Adjusting Blade Shaft Drive Belt TensionReplacing the Jackshaft Belt Replacing the Blade Shaft BeltDo not OVER-TIGHTEN Rotary Belt TensionerBlade Shaft Replacement Blade Shaft MaintenanceRemoving the Inner Blade Collar Blade Collar Removal/InstallationInstalling the Inner Blade Collar Installing the Inner Blade CollarInner Collar Blade Shaft Circuit Breakers Maximum Cut Depth AdjustmentLubrication Engine Air and Oil Filter ChartAttaching the PTO Bearing Puller to the Drive Plate Assembly PTO Drive MaintenanceRe-Assembling the PTO Drive PTO Drive Sheave/Bearing AssemblyRotate Engine Forward to Remove the Battery Replacing the BatteryRaise-Lower System Raise/Lower TroubleshootingJoystick Adjustment Joystick Tension AdjustmentRoutine Maintenance Hydraulic System MaintenanceTo drain the hydraulic system Draining & Filling the Hydraulic SystemTo fill the hydraulic system with oil Bleeding the Depth Stop Cylinder Bleeding the Depth Stop CylinderDrive Wheel Alignment Drive Wheel AlignmentPivot Side Adjustment Side Specifications Dimensions and Weights Www multiquip.com