Woodstock Model owner manual Clean Up

Page 15

Clean Up

The exposed, unpainted surfaces of the machine have been coated with an oil to prevent rust during shipment. This oil needs to be removed before operation. To remove the oil, we recom- mend using a solvent based degreaser. Avoid using any chlorine based solutions because they will damage the painted surfaces. Always follow the instructions of the product being used.

Do not use gasoline or other petroleum-based solvents. They have low flash points which make them extremely flamma- ble. A risk of explosion and burning exists if these products are used . Serious personal injury may occur if this warning is ignored.

Do not smoke while using solvents. A risk of explo- sion or fire exists and may result in serious personal injury.

Many of the solvents com- monly used to clean machinery can be toxic when inhaled or ingested. Always work in well-ven- tilated areas far from potential ignition sources when dealing with sol- vents. Use care when dis- posing of waste rags and towels to be sure they do not create fire or envi- ronmental hazards.

-12-

Image 15

Contents Model W1676 Box ContentsCombination Sander Page Table Of Contents Introduction About Your NEW Sander Woodstock Service and SupportMachine Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstKeep proper footing and balance at all times Keep fingertips away from the moving belt or disc Additional Safety Instructions For SandersGrounding Electrical Requirements110V Operation Extension Cords220V Operation Never place fingers close to moving disk Avoiding Potential InjuriesUnpacking Assembly InstructionsQTY Clean Up General Sanding Unit To Base Idler RollerSanding Disc Dust Ports Back StopTo install the working table next to the disc Working TableQuick Release Adjustments Belt Tracking/Tension To adjust the tracking Unplug the combination sanderIdler Guard To adjust the tensionVertical positioning bolts Vertical PositioningTo replace abrasive sanding disc Changing Abrasive DiscTable Tilt To adjust the working table angleOperations TestingCurved Sanding Horizontal SandingSanding end grain Disc SandingMaintenance Table And BaseLubrication Closure 220VOLT W1676 Combination Sander120 107 90A 110 104 122 Description Page Page Warranty Card BOX BELLINGHAM, WA