Figure 26. Opening pulley door.
Figure 27. Changing abrasive disc with table off.
Figure 28. Changing abrasive disc with table on.
Changing Abrasive Disc
To replace abrasive sanding disc:
1.Remove the working table assembly.
2.Remove the knob holding the pulley cover door shut and open the door as shown in
Figure 26.
3.Remove the worn sanding disc and the new sanding disc. Be sure to center the new sand- ing disc over the cast iron disc before press- ing it down as shown in Figure 27.
4.Another option allows you to leave the pul- ley cover and working table attached. Peel back half of the abrasive disc backing and slip the covered portion behind the closed pulley door. Stick the peeled back portion of the abrasive disc to the top half of the sand- ing wheel. Carefully rotate the disc 180°. Peel back the second half of the abrasive backing and stick the remaining portion to the sanding disc as shown in Figure 28. Press then entire disc on to ensure good adhesion.