Woodstock Model Working Table, Quick Release, To install the working table next to the disc

Page 19

Working Table

The working table has two mounting locations: next to the sanding disc and next to the verti- cally positioned belt sander. We recommend ini- tially mounting the working table next to the disc. If you want to mount it next to the verti- cally positioned belt sander, skip to the “Vertical Positioning” instructions in the Adjustment section.

To install the working table next to the disc:

1.Loosen the (2) 516"-18 x 38" setscrews locat- ed in the base, directly beneath the pulley cover.

2.Insert the support bar into the hole in the base that is adjacent to the setscrew holes. Make sure that the flat side of the support bar is facing the setscrews.

3.Securely tighten the setscrews as shown in

Figure 15.

4.Slide the working table assembly onto the end of the support bar and securely tighten the setscrews located in the table support bracket as shown in Figure 16. Be sure to leave no more than a 116" gap between the disc and the edge of the working table.

Quick Release

The quick release lever is used to loosen the tension on the sanding belt. To install the quick release lever:

1.Thread a 38"-16 hex nut on each end of the quick release levers.

2.Thread the ends of the levers into the threaded holes in the short lever and the rocker arm.

3.Finally, position the levers as shown in Figure 17 and tighten down the hex nuts.

Figure 15. Tightening the setscrews.

Figure 16. Tightening the setscrews.

Rocker Arm

Short Lever

Figure 17. Installing the quick release.

-16-

Image 19
Contents Model W1676 Box ContentsCombination Sander Page Table Of Contents Introduction About Your NEW Sander Woodstock Service and SupportMachine Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstKeep proper footing and balance at all times Keep fingertips away from the moving belt or disc Additional Safety Instructions For SandersGrounding Electrical Requirements110V Operation Extension Cords220V Operation Never place fingers close to moving disk Avoiding Potential InjuriesUnpacking Assembly InstructionsQTY Clean Up General Idler Roller Sanding Unit To BaseSanding Disc Dust Ports Back StopWorking Table To install the working table next to the discQuick Release Adjustments Belt Tracking/Tension To adjust the tracking Unplug the combination sanderIdler Guard To adjust the tensionVertical positioning bolts Vertical PositioningTo replace abrasive sanding disc Changing Abrasive DiscTable Tilt To adjust the working table angleOperations TestingCurved Sanding Horizontal SandingSanding end grain Disc SandingTable And Base MaintenanceLubrication Closure 220VOLT W1676 Combination Sander120 107 90A 110 104 122 Description Page Page Warranty Card BOX BELLINGHAM, WA