Woodstock Model owner manual Warranty and Returns, Machine Specifications

Page 6

WARRANTY AND RETURNS

Woodstock International, Inc. warrants all SHOP FOX® machinery to be free of defects from workman- ship and materials for a period of 2 years from the date of original purchase by the original owner. This warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence or accidents, lack of maintenance, or to repairs or alterations made or specifically authorized by anyone other than Woodstock International, Inc.

Woodstock International, Inc. will repair or replace, at its expense and at its option, the SHOP FOX® machine or machine part which in normal use has proven to be defective, provided that the original owner returns the product prepaid to the SHOP FOX® factory service center or authorized repair facility designated by our Bellingham, WA office, with proof of their purchase of the product within 2 years, and provides Woodstock International, Inc. reasonable opportunity to verify the alleged defect through inspection. If it is determined there is no defect, or that the defect resulted from causes not within the scope of Woodstock International Inc.'s warranty, then the original owner must bear the cost of storing and returning the product.

This is Woodstock International, Inc.'s sole written warranty and any and all warranties that may be implied by law, including any merchantability or fitness, for any particular purpose, are hereby limited to the duration of this written warranty. We do not warrant that SHOP FOX® machinery complies with the provisions of any law or acts. In no event shall Woodstock International, Inc.'s liability under this war- ranty exceed the purchase price paid for the product, and any legal actions brought against Woodstock International, Inc. shall be tried in the State of Washington, County of Whatcom. We shall in no event be liable for death, injuries to persons or property or for incidental, contingent, special or consequen- tial damages arising from the use of our products.

Every effort has been made to ensure that all SHOP FOX® machinery meets high quality and durability standards. We reserve the right to change specifications at any time because of our commitment to con- tinuously improve the quality of our products.

Machine Specifications

Motor Size:

1 H.P., 110/220V Single-Phase

Motor Speed

3450 R.P.M.

Amps

14/7

Sanding Belt

6" x 48"

Belt Speed

1900 F.P.M.

Sanding Disc

10"

Disc Speed

2420 R.P.M.

Table (Disc)

6" x 1214"

Stand

Cabinet Style, Powder Coated Paint

Power Transfer

Belt Drive (3L-240)

Bearings

Shielded & Lubricated Ball Bearings

Switch

Paddle ON/OFF Switch, w/ Safety Lock Key

Shipping Weight

170 lbs.

-3-

Image 6
Contents Box Contents Model W1676Combination Sander Page Table Of Contents Woodstock Service and Support Introduction About Your NEW SanderWarranty and Returns Machine SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingKeep proper footing and balance at all times Additional Safety Instructions For Sanders Keep fingertips away from the moving belt or discExtension Cords Electrical Requirements110V Operation Grounding220V Operation Avoiding Potential Injuries Never place fingers close to moving diskAssembly Instructions UnpackingQTY Clean Up General Sanding Unit To Base Idler RollerSanding Disc Back Stop Dust PortsTo install the working table next to the disc Working TableQuick Release Adjustments To adjust the tracking Unplug the combination sander Belt Tracking/TensionTo adjust the tension Idler GuardVertical Positioning Vertical positioning boltsChanging Abrasive Disc To replace abrasive sanding discTo adjust the working table angle Table TiltTesting OperationsHorizontal Sanding Curved SandingDisc Sanding Sanding end grainMaintenance Table And BaseLubrication Closure W1676 Combination Sander 220VOLT120 107 90A 110 104 122 Description Page Page Warranty Card BOX BELLINGHAM, WA