Woodstock Model owner manual Maintenance, Table And Base, Lubrication

Page 29

MAINTENANCE

General

Regular periodic maintenance on your Model W1676 will ensure its optimum performance. Make a habit of inspecting your sander each time you use it. Check for the following conditions and repair or replace when necessary.

1.Loose mounting bolts.

2.Worn switch.

3.Worn or damaged cords and plugs.

4.Damaged sanding belts or discs.

5.Any other condition that could hamper the safe operation of this machine.

Table And Base

Tables can be kept rust-free with regular appli- cations of products like Boeshield® T-9. For long term storage you may want to consider products like Kleen Bore's Rust Guardit™.

!

Disconnect power to the

machine when perform-

ing

any

maintenance,

 

assembly

or

adjust-

 

ments. Failure to do this

 

may

result in

serious

 

personal injury.

 

Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.

Wear safety glasses dur- ing the entire mainte- nance process. Failure to comply may result in serious personal injury.

Lubrication

Since all bearings are sealed and permanently lubricated, simply leave them alone until they need to be replaced. Do not lubricate them.

For other items on this machine, an occasional application of light machine oil is all that is nec- essary. Before applying lubricant, wipe the machine clean.

Your goal is to achieve adequate lubrication. Too much lubrication will attract dirt and saw- dust. Various parts of your machine could lose their freedom of movement as a result.

-26-

Image 29
Contents Model W1676 Box ContentsCombination Sander Page Table Of Contents Introduction About Your NEW Sander Woodstock Service and SupportMachine Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstKeep proper footing and balance at all times Keep fingertips away from the moving belt or disc Additional Safety Instructions For Sanders110V Operation Electrical RequirementsExtension Cords Grounding220V Operation Never place fingers close to moving disk Avoiding Potential InjuriesUnpacking Assembly InstructionsQTY Clean Up General Sanding Disc Sanding Unit To BaseIdler Roller Dust Ports Back StopQuick Release To install the working table next to the discWorking Table Adjustments Belt Tracking/Tension To adjust the tracking Unplug the combination sanderIdler Guard To adjust the tensionVertical positioning bolts Vertical PositioningTo replace abrasive sanding disc Changing Abrasive DiscTable Tilt To adjust the working table angleOperations TestingCurved Sanding Horizontal SandingSanding end grain Disc SandingLubrication MaintenanceTable And Base Closure 220VOLT W1676 Combination Sander120 107 90A 110 104 122 Description Page Page Warranty Card BOX BELLINGHAM, WA