Woodstock Model owner manual General

Page 16

!	Disconnect power to the
	machine when perform-
	ing	any	maintenance,
	assembly		or	adjust-
	ments. Failure to do this
	may	result in		serious
	personal injury.

Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.

Wear safety glasses dur- ing the entire assembly process. Failure to com- ply may result in serious personal injury.

General

While the main components of the Shop Fox® W1676 are assembled at the factory, some assembly is required. The following is the rec- ommended sequence best suited for final assembly.

TOOLS REQUIRED (NOT INCLUDED): You will need a 6" adjustable wrench, 12mm open-end wrench, flathead screwdriver, Phillips® screw- driver and 4mm Allen® wrench.

-13-

Image 16

Contents Box Contents Model W1676Combination Sander Page Table Of Contents Woodstock Service and Support Introduction About Your NEW SanderWarranty and Returns Machine SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingKeep proper footing and balance at all times Additional Safety Instructions For Sanders Keep fingertips away from the moving belt or discElectrical Requirements 110V OperationExtension Cords Grounding220V Operation Avoiding Potential Injuries Never place fingers close to moving diskAssembly Instructions UnpackingQTY Clean Up General Idler Roller Sanding Unit To BaseSanding Disc Back Stop Dust PortsWorking Table To install the working table next to the discQuick Release Adjustments To adjust the tracking Unplug the combination sander Belt Tracking/TensionTo adjust the tension Idler GuardVertical Positioning Vertical positioning boltsChanging Abrasive Disc To replace abrasive sanding discTo adjust the working table angle Table TiltTesting OperationsHorizontal Sanding Curved SandingDisc Sanding Sanding end grainTable And Base MaintenanceLubrication Closure W1676 Combination Sander 220VOLT120 107 90A 110 104 122 Description Page Page Warranty Card BOX BELLINGHAM, WA