Woodstock Model owner manual Combination Sander

Page 2

MODEL W1676

COMBINATION SANDER

INSTRUCTION MANUAL

Phone: 1-360-734-3482On-Line Technical Support: tech-support@woodstockint.com

COPYRIGHT © 2001 BY WOODSTOCK INTERNATIONAL, INC.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT

THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.

Printed in Taiwan

Image 2
Contents Box Contents Model W1676Combination Sander Page Table Of Contents Woodstock Service and Support Introduction About Your NEW SanderWarranty and Returns Machine SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingKeep proper footing and balance at all times Additional Safety Instructions For Sanders Keep fingertips away from the moving belt or discExtension Cords Electrical Requirements110V Operation Grounding220V Operation Avoiding Potential Injuries Never place fingers close to moving diskAssembly Instructions UnpackingQTY Clean Up General Sanding Disc Sanding Unit To BaseIdler Roller Back Stop Dust PortsQuick Release To install the working table next to the discWorking Table Adjustments To adjust the tracking Unplug the combination sander Belt Tracking/TensionTo adjust the tension Idler GuardVertical Positioning Vertical positioning boltsChanging Abrasive Disc To replace abrasive sanding discTo adjust the working table angle Table TiltTesting OperationsHorizontal Sanding Curved SandingDisc Sanding Sanding end grainLubrication MaintenanceTable And Base Closure W1676 Combination Sander 220VOLT120 107 90A 110 104 122 Description Page Page Warranty Card BOX BELLINGHAM, WA