Woodstock Model owner manual Sanding Unit To Base, Idler Roller, Sanding Disc

Sanding Unit To Base

The Model W1676 comes with a prefabricated welded steel stand that requires no assembly. However, the sanding unit needs to be mounted to the stand.

The W1676 represents a heavy load at 170 pounds. Seek assistance before beginning assem- bly.

1.With the help of a friend, lift the main sand- ing unit on top of the steel stand.

2.Align the four mounting holes in the stand with the slots on the bottom corners of the sanding unit as shown in Figure 9.

3.Using (4) 5⁄16"-18 x 1⁄2" hex bolts, 5⁄16" wash- ers and 5⁄16" nuts, fasten the sanding unit to the stand.

Idler Roller

Install the idler roller by inserting its flat axle ends into the slots on the ends of the adjust- ments bar as shown in Figure 10.

NOTICE

Until the sanding belt is installed, along with the idler guard, the idler roller can fall off causing damage.

Sanding Disc

The sanding disc is installed onto the keyed drive shaft using a 5⁄16"-18 x 3⁄8" setscrew as shown in Figure 11. For clearance purposes, we have included a long shaft 4mm Allen® wrench.

-14-

Figure 9. Stand mounting holes.

Figure 10. Idler roller.

Figure 11. Installing sanding disk.