Woodstock Model owner manual Back Stop, Dust Ports

Page 18

Figure 12. Installing back stop.

Figure 13. Installing dust port.

Figure 14. Disc sanding dust port.

Back Stop

The back stop serves as a resting point for the workpiece while flat sanding on the belt. Install the back stop to the sanding belt frame using a

5⁄16"-18 x 1" hex bolt and a 5⁄16" flat washer as shown in Figure 12. The back stop can be removed when sanding long workpieces.

Dust Ports

The dust ports are designed to reduce the amount of dust on the sander and in the air. Fasten the belt dust port to the sanding belt frame using (2) Phillips® head screws as shown in Figure 13. Fasten the disc dust port using (4) Phillips® head screws and nuts as shown in

Figure 14.

Always wear a dust mask when operating the W1676. Using this machine produces saw- dust which may cause allergic reactions or res- piratory problems.

-15-

Image 18

Contents Box Contents Model W1676Combination Sander Page Table Of Contents Woodstock Service and Support Introduction About Your NEW SanderWarranty and Returns Machine SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingKeep proper footing and balance at all times Additional Safety Instructions For Sanders Keep fingertips away from the moving belt or discExtension Cords Electrical Requirements110V Operation Grounding220V Operation Avoiding Potential Injuries Never place fingers close to moving diskAssembly Instructions UnpackingQTY Clean Up General Sanding Unit To Base Idler RollerSanding Disc Back Stop Dust PortsTo install the working table next to the disc Working TableQuick Release Adjustments To adjust the tracking Unplug the combination sander Belt Tracking/TensionTo adjust the tension Idler GuardVertical Positioning Vertical positioning boltsChanging Abrasive Disc To replace abrasive sanding discTo adjust the working table angle Table TiltTesting OperationsHorizontal Sanding Curved SandingDisc Sanding Sanding end grainMaintenance Table And BaseLubrication Closure W1676 Combination Sander 220VOLT120 107 90A 110 104 122 Description Page Page Warranty Card BOX BELLINGHAM, WA