Woodstock Model owner manual Additional Safety Instructions For Sanders

Page 9

Additional Safety Instructions For Sanders

1.Be aware of belt or disc rotation when sanding. Always brace workpiece against the rotation of the sanding belt. Always sand on the side of the disc that is rotating downward, towards the work table.

2.Keep fingertips away from the moving belt or disc.

3.Never use excessive force when sanding. Doing this greatly increases the chances of personal injury and motor overload.

4.Always feed the work against the direction of rotation.

5.Even if you have a reliable method of dust collection, use a dust mask or respirator when sanding, as well as eye and ear protection.

6.If there is any doubt as to the stability or integrity of the material to be sanded, do not sand it.

7.Do not operate sander with a damaged or badly worn disc or belt.

8.Habits — good or bad — are hard to break. Develop good habits and safety will become second nature to you.

9.Sanding dust from some woods may be toxic or cause an allergic reaction. Be sure to wear an appropriate respirator when working around saw dust. Make sure there is adequate ventilation or a constant source of fresh air. The saw dust from some species of wood can be toxic to some people. Be sure to research the dangers of the specific species of wood you are working with.

Read the manual before assembly and operation. Become familiar with the machine and its operation before begin- ning any work. Serious personal injury may result if safety or opera- tional information is not understood or followed.

No list of safety guidelines can be complete. Every shop environment is different. Always consider safety first, as it applies to your individual working conditions. Use this and other machinery with caution and respect. Failure to follow guidelines could result in serious personal injury, damage to equip- ment or poor work results.

-6-

Image 9
Contents Model W1676 Box ContentsCombination Sander Page Table Of Contents Introduction About Your NEW Sander Woodstock Service and SupportMachine Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstKeep proper footing and balance at all times Keep fingertips away from the moving belt or disc Additional Safety Instructions For Sanders110V Operation Electrical RequirementsExtension Cords Grounding220V Operation Never place fingers close to moving disk Avoiding Potential InjuriesUnpacking Assembly InstructionsQTY Clean Up General Sanding Unit To Base Idler RollerSanding Disc Dust Ports Back StopTo install the working table next to the disc Working TableQuick Release Adjustments Belt Tracking/Tension To adjust the tracking Unplug the combination sanderIdler Guard To adjust the tensionVertical positioning bolts Vertical PositioningTo replace abrasive sanding disc Changing Abrasive DiscTable Tilt To adjust the working table angleOperations TestingCurved Sanding Horizontal SandingSanding end grain Disc SandingMaintenance Table And BaseLubrication Closure 220VOLT W1676 Combination Sander120 107 90A 110 104 122 Description Page Page Warranty Card BOX BELLINGHAM, WA