Woodstock Model owner manual Operations, Testing

Page 26

OPERATIONS

!

Disconnect power to the

machine when perform-

ing

any

maintenance,

 

assembly

or

adjust-

 

ments. Failure to do this

 

may

result in

serious

 

personal injury.

 

Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.

Wear safety glasses dur- ing the entire operations process. Failure to com- ply may result in serious personal injury.

Testing

Once assembly is complete and adjustments have been made, the machine is ready for a test run. The purpose of a test run is to identify any unusual noises and vibrations, as well as to con- firm the machine is performing as intended.

1.Turn the machine on by pulling the START paddle on the power switch. Be sure to have your finger poised to push the paddle in if there is a problem.

2.Once the machine is running, listen for any unusual noises. The machine should run smoothly with little or no vibrations.

3.If there are any unusual noises or vibrations, shut the machine off immediately. The machine should not be run any further until the problems are corrected.

4.Unplug the machine and investigate the source of the noise or vibration. Do not make any adjustments to the machine while it is plugged in.

Always wear a dust mask when operating the W1676. Using this machine produces saw- dust which may cause allergic reactions or respiratory problems.

-23-

Image 26
Contents Box Contents Model W1676Combination Sander Page Table Of Contents Woodstock Service and Support Introduction About Your NEW SanderWarranty and Returns Machine SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingKeep proper footing and balance at all times Additional Safety Instructions For Sanders Keep fingertips away from the moving belt or discExtension Cords Electrical Requirements110V Operation Grounding220V Operation Avoiding Potential Injuries Never place fingers close to moving diskAssembly Instructions UnpackingQTY Clean Up General Sanding Disc Sanding Unit To BaseIdler Roller Back Stop Dust PortsQuick Release To install the working table next to the discWorking Table Adjustments To adjust the tracking Unplug the combination sander Belt Tracking/TensionTo adjust the tension Idler GuardVertical Positioning Vertical positioning boltsChanging Abrasive Disc To replace abrasive sanding discTo adjust the working table angle Table TiltTesting OperationsHorizontal Sanding Curved SandingDisc Sanding Sanding end grainLubrication MaintenanceTable And Base Closure W1676 Combination Sander 220VOLT120 107 90A 110 104 122 Description Page Page Warranty Card BOX BELLINGHAM, WA