Woodstock Model owner manual Table Tilt, To adjust the working table angle

Page 25

Table Tilt

To adjust the working table angle:

1.Set the working table angle to the 90° mark on the scale.

2.Using a 90° square, adjust the working table so it is perpendicular to the sanding disc as shown in Figure 29.

3.Loosen the screw holding the angle indicator and set it to the 90° mark on the scale.

4.Using a 90° square, check to see if the miter slot is perpendicular to the sanding disc as shown in Figure 30.

5.To adjust, loosen the three screws shown in Figure 31. Wiggle the table until the miter slot is parallel to the sanding disc and tight- en the adjustment screws.

Make sure the gap between the working table edge and the sanding disc is no larger than 1⁄8". Your fingers could get caught in the gap, causing serious personal injury.

Figure 29. Checking table alignment.

Figure 30. Checking miter gauge alignment.

Figure 31. Table adjustment screws.

-22-

Image 25

Contents Model W1676 Box ContentsCombination Sander Page Table Of Contents Introduction About Your NEW Sander Woodstock Service and SupportMachine Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstKeep proper footing and balance at all times Keep fingertips away from the moving belt or disc Additional Safety Instructions For Sanders110V Operation Electrical RequirementsExtension Cords Grounding220V Operation Never place fingers close to moving disk Avoiding Potential InjuriesUnpacking Assembly InstructionsQTY Clean Up General Idler Roller Sanding Unit To BaseSanding Disc Dust Ports Back StopWorking Table To install the working table next to the discQuick Release Adjustments Belt Tracking/Tension To adjust the tracking Unplug the combination sanderIdler Guard To adjust the tensionVertical positioning bolts Vertical PositioningTo replace abrasive sanding disc Changing Abrasive DiscTable Tilt To adjust the working table angleOperations TestingCurved Sanding Horizontal SandingSanding end grain Disc SandingTable And Base MaintenanceLubrication Closure 220VOLT W1676 Combination Sander120 107 90A 110 104 122 Description Page Page Warranty Card BOX BELLINGHAM, WA