Woodstock Model owner manual Vertical Positioning, Vertical positioning bolts

Page 23

Vertical Positioning

The belt sander arm can be moved to a vertical arrangement.

1.Remove the belt dust port.

2.Loosen the two nuts located on the bracket behind the pulley cover as shown in Figure 23. We recommend using a 12mm open-end wrench for clearance purposes.

3.When the nuts are loose, rotate the sanding belt frame to the vertical position as shown in Figure 24.

4.Tighten down the nuts that were loosened in Step 2.

The working table can also be repositioned next to the vertical surface of the sanding belt. Remove the working table assembly and support bar from the sander base, and reposition it in the mounting hole behind the motor as shown in

Figure 25.

Figure 23. Vertical positioning bolts.

Figure 24. Belt sander in vertical position.

Figure 25. Working table mounting hole when

vertical sanding.

-20-

Image 23

Contents Model W1676 Box ContentsCombination Sander Page Table Of Contents Introduction About Your NEW Sander Woodstock Service and SupportMachine Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstKeep proper footing and balance at all times Keep fingertips away from the moving belt or disc Additional Safety Instructions For SandersGrounding Electrical Requirements110V Operation Extension Cords220V Operation Never place fingers close to moving disk Avoiding Potential InjuriesUnpacking Assembly InstructionsQTY Clean Up General Sanding Disc Sanding Unit To BaseIdler Roller Dust Ports Back StopQuick Release To install the working table next to the discWorking Table Adjustments Belt Tracking/Tension To adjust the tracking Unplug the combination sanderIdler Guard To adjust the tensionVertical positioning bolts Vertical PositioningTo replace abrasive sanding disc Changing Abrasive DiscTable Tilt To adjust the working table angleOperations TestingCurved Sanding Horizontal SandingSanding end grain Disc SandingLubrication MaintenanceTable And Base Closure 220VOLT W1676 Combination Sander120 107 90A 110 104 122 Description Page Page Warranty Card BOX BELLINGHAM, WA