Woodstock Model owner manual W1676 Combination Sander, 220VOLT

Page 31

Disconnect power from machine before performing any electrical service. Failure to do this will result in a shock hazard leading to injury or death.

W1676 Combination Sander

110 VOLT

MOTOR WIRES

BLACK

YELLOW

WHITE

RED

NOTE: THE WIRES FROM THE POWER SUPPLY, BESIDES THE GREEN GROUND WIRE, ARE INTERCHANGABLE, THEREFORE COLORS ARE NOT SPECIFIED.

GREEN (GROUND) TO 110 VOLT POWER SUPPLY

6A

220VOLT

		MOTOR WIRES

	BLACK			YELLOW

RED
RED					WHITE

GREEN (GROUND)

TO 220 VOLT

POWER SUPPLY

-28-

©2001 Woodstock International

Image 31

Contents Model W1676 Box ContentsCombination Sander Page Table Of Contents Introduction About Your NEW Sander Woodstock Service and SupportMachine Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstKeep proper footing and balance at all times Keep fingertips away from the moving belt or disc Additional Safety Instructions For SandersGrounding Electrical Requirements110V Operation Extension Cords220V Operation Never place fingers close to moving disk Avoiding Potential InjuriesUnpacking Assembly InstructionsQTY Clean Up General Idler Roller Sanding Unit To BaseSanding Disc Dust Ports Back StopWorking Table To install the working table next to the discQuick Release Adjustments Belt Tracking/Tension To adjust the tracking Unplug the combination sanderIdler Guard To adjust the tensionVertical positioning bolts Vertical PositioningTo replace abrasive sanding disc Changing Abrasive DiscTable Tilt To adjust the working table angleOperations TestingCurved Sanding Horizontal SandingSanding end grain Disc SandingTable And Base MaintenanceLubrication Closure 220VOLT W1676 Combination Sander120 107 90A 110 104 122 Description Page Page Warranty Card BOX BELLINGHAM, WA