Woodstock W1747 owner manual Contents

Page 3

Contents
INTRODUCTION	3
Woodstock Technical Support	3
Specifications	4
Controls and Features	5
SAFETY	6
Standard Safety Instructions	6
Additional Safety Instructions for Planers	8
ELECTRICAL	9
220V Operation	9
Extension Cords	9
Grounding	9
SET UP	10
Unpacking	10
Items Needed for Set Up	10
Inventory	10
Machine Placement	11
Lifting Planer	11
Cleaning Machine	12
Extension Wings	13
Handwheel	14
Dust Hood	14
Gearbox Oil Level	15
Connecting to Power	15
Knife Setting Gauge	15
Test Run	16
Tighten V-Belts	16
Recommended Adjustments	16
OPERATIONS	17
General	17
Basic Operation	17
Operation Tips	18
Feed Speed	19
Bed Rollers	20
ACCESSORIES	21
Planer Accessories	21
MAINTENANCE	23
General	23
Cleaning	23
Maintenance Schedule	23
V-Belts	24
Lubrication	25

INTRODUCTION SAFETY ELECTRICAL

SET UP OPERATIONS MAINTENANCE SERVICE

USE THE QUICK GUIDE PAGE LABELS TO SEARCH OUT INFORMATION FAST!

PARTS

Image 3

Contents Planer Page Contents Service Woodstock Technical Support IntroductionSpecifications Controls and Features Standard Safety Instructions SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Planers Grounding Electrical220V Operation Extension CordsInventory SET UPItems Needed for Set Up UnpackingMachine Placement Lifting PlanerHardware and Tools These items are coated and must be cleaned Cleaning MachineExtension wing fasteners Leveling controls Extension WingsTo install the handwheel, do these steps HandwheelDust Hood To check the gearbox oil level, do these steps Connecting to PowerKnife Setting Gauge Gearbox Oil LevelTo perform a test run, do these steps Recommended AdjustmentsTest Run Tighten V-BeltsBasic steps of operating the planer are as follows OperationsGeneral Basic OperationOperation Tips Feed control knob positions Feed SpeedAdjustment Height Range 002-0.020 To adjust the bed rollers, do these stepsBed Rollers Planer Accessories AccessoriesOFF Maintenance CleaningMaintenance Schedule Belts To adjust/replace the V-belts, do these stepsLubrication Service Inspecting KnivesTo inspect the knives, do these steps To set the knives, do these steps Setting/Replacing KnivesChain Tension To adjust the chain tension, do these stepsMaximum Allowable Tolerances Table ParallelismTable micro-adjustment screws To adjust the table parallelism, do these stepsDistance Below Knife Edge at *BDC Rollers, Chip Breaker Pressure Bar Heights27, 28, Roller height adjustmentService Spring Tension To adjust roller spring tension, do these stepsTo calibrate the scale, do these steps Chip Deflector Gap SettingTo adjust the deflector position, do these steps Scale CalibrationAnti-kickback fingers Anti-Kickback FingersChecking belt alignment Pulley AlignmentW1747 motor junction box W1747 Electrical ComponentsW1747 Wiring Diagram Moving parts have come to a complete stop TroubleshootingCutting Headstock Assembly Parts Breakdown PART# Description Headstock Assembly Parts ListXPN09M Table, Base, and Columns Parts Breakdown Table, Base, and Columns Parts List Stand/Motor Assembly Parts Breakdown Stand/Motor Assembly Parts List Parts Warranty Comments Warranty RegistrationBOX BELLINGHAM, WA