Woodstock W1747 owner manual 27, 28, Roller height adjustment

Page 34

			W1747 20" Planer
7.	Adjust the height of the infeed roller on the same
	side as the Rotacator to the specification given at	Infeed
	the beginning of this procedure, using the zero set-	Infeed		OFF
	ting of the Rotacator as a reference point. Figure 27	Roller
	ting of the Rotacator as a reference point. Figure 27
	shows the jam nut and set screw for adjusting the
	roller height.
8.	Repeat Steps 6–7on the left-hand side of the infeed			Outfeed
8.	Repeat Steps 6–7on the left-hand side of the infeed		Jam	Roller
	roller.			Roller

			Nuts
			Nuts
9.	Double-check and micro-adjust both sides of the	Set		Set
	infeed roller, then carefully lock both sides in place.	Screw		Screw
10.	Using the same zeroed reference on the Rotacator,	Figure 27. Roller height adjustment
	adjust the height of the outfeed roller, pressure bar,	Figure 27. Roller height adjustment
	and chip breaker to their given specifications. The		controls.
	adjustment controls for each are shown in Figures
	27, 28, and 29.
				OFF

Pressure

Bar

Adjustment

Location

SERVICE

Figure 28. Pressure bar height adjustment

controls.

OFF

Adjustment

Location

Chip Breaker

Figure 29. Adjusting chip breaker height.

-32-

Image 34

Contents Planer Page Contents Service Introduction Woodstock Technical SupportSpecifications Controls and Features Safety Standard Safety InstructionsAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Planers Extension Cords Electrical220V Operation GroundingUnpacking SET UPItems Needed for Set Up InventoryLifting Planer Machine PlacementHardware and Tools Cleaning Machine These items are coated and must be cleanedExtension Wings Extension wing fasteners Leveling controlsHandwheel To install the handwheel, do these stepsDust Hood Gearbox Oil Level Connecting to PowerKnife Setting Gauge To check the gearbox oil level, do these stepsTighten V-Belts Recommended AdjustmentsTest Run To perform a test run, do these stepsBasic Operation OperationsGeneral Basic steps of operating the planer are as followsOperation Tips Feed Speed Feed control knob positionsTo adjust the bed rollers, do these steps Adjustment Height Range 002-0.020Bed Rollers Accessories Planer AccessoriesOFF Cleaning MaintenanceMaintenance Schedule To adjust/replace the V-belts, do these steps BeltsLubrication Inspecting Knives ServiceTo inspect the knives, do these steps Setting/Replacing Knives To set the knives, do these stepsTo adjust the chain tension, do these steps Chain Tension Table Parallelism Maximum Allowable TolerancesTo adjust the table parallelism, do these steps Table micro-adjustment screwsRollers, Chip Breaker Pressure Bar Heights Distance Below Knife Edge at *BDCRoller height adjustment 27, 28,Service To adjust roller spring tension, do these steps Spring TensionScale Calibration Chip Deflector Gap SettingTo adjust the deflector position, do these steps To calibrate the scale, do these stepsAnti-Kickback Fingers Anti-kickback fingersPulley Alignment Checking belt alignmentW1747 Electrical Components W1747 motor junction boxW1747 Wiring Diagram Troubleshooting Moving parts have come to a complete stopCutting Headstock Assembly Parts Breakdown Headstock Assembly Parts List PART# DescriptionXPN09M Table, Base, and Columns Parts Breakdown Table, Base, and Columns Parts List Stand/Motor Assembly Parts Breakdown Stand/Motor Assembly Parts List Parts Warranty Warranty Registration CommentsBOX BELLINGHAM, WA