Woodstock W1747 owner manual Planer

Page 1

MODEL W1747

20" PLANER

OWNER'S MANUAL

Phone: (360) 734-3482 • Online Technical Support: tech-support@shopfox.biz

 

COPYRIGHT © SEPTEMBER, 2006 BY WOODSTOCK INTERNATIONAL, INC.

 

 

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT

 

#8426BL

THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.

Printed in China

 

Image 1
Contents Planer Page Contents Service Woodstock Technical Support IntroductionSpecifications Controls and Features Standard Safety Instructions SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Planers 220V Operation ElectricalExtension Cords GroundingItems Needed for Set Up SET UPUnpacking InventoryLifting Planer Machine PlacementHardware and Tools These items are coated and must be cleaned Cleaning MachineExtension wing fasteners Leveling controls Extension WingsHandwheel To install the handwheel, do these stepsDust Hood Knife Setting Gauge Connecting to PowerGearbox Oil Level To check the gearbox oil level, do these stepsTest Run Recommended AdjustmentsTighten V-Belts To perform a test run, do these stepsGeneral OperationsBasic Operation Basic steps of operating the planer are as followsOperation Tips Feed control knob positions Feed SpeedTo adjust the bed rollers, do these steps Adjustment Height Range 002-0.020Bed Rollers Planer Accessories AccessoriesOFF Cleaning MaintenanceMaintenance Schedule Belts To adjust/replace the V-belts, do these stepsLubrication Inspecting Knives ServiceTo inspect the knives, do these steps To set the knives, do these steps Setting/Replacing KnivesChain Tension To adjust the chain tension, do these stepsMaximum Allowable Tolerances Table ParallelismTable micro-adjustment screws To adjust the table parallelism, do these stepsDistance Below Knife Edge at *BDC Rollers, Chip Breaker Pressure Bar Heights27, 28, Roller height adjustmentService Spring Tension To adjust roller spring tension, do these stepsTo adjust the deflector position, do these steps Chip Deflector Gap SettingScale Calibration To calibrate the scale, do these stepsAnti-kickback fingers Anti-Kickback FingersChecking belt alignment Pulley AlignmentW1747 motor junction box W1747 Electrical ComponentsW1747 Wiring Diagram Moving parts have come to a complete stop TroubleshootingCutting Headstock Assembly Parts Breakdown PART# Description Headstock Assembly Parts ListXPN09M Table, Base, and Columns Parts Breakdown Table, Base, and Columns Parts List Stand/Motor Assembly Parts Breakdown Stand/Motor Assembly Parts List Parts Warranty Comments Warranty RegistrationBOX BELLINGHAM, WA