Woodstock W1812 manual IfneDflc`eJlggfik

N(/()Fne\ijDXelXcD]^%j`eZ\*&'0

:ifneDflc[`e^Jlggfik

When cutting crown moulding (Figure 37), make a wood- en V-track that can be clamped to the table. The V-track must support at least 50% of the workpiece height on both sides.

Do not use the guide rails that came with your machine for crown moulding support. If you do, the workpiece can dislodge and be ejected from the machine, causing severe injury or damage.

Be`]\Gfj`k`fe`e^

Depending on the knife profile and the hardness of the workpiece, to minimize the potential for vibration and chatter marks on the workpiece, install moulding knives closer to column rather than farther away (Figure 38).

REMEMBER, moulding knives have many different pro- files, before starting the machine, always verify that the moulding knives do not contact any part of the workpiece guide rails, feed roller swing arm, or the table surface. =X`cli\ kf m\i`]p be`]\ Zc\XiXeZ\ dXp i\jlck`ej\m\i\`ealipXe[dXZ_`e\[XdX^\

CORRECT

INCORRECT

Figure 37. Crown moulding track.

CORRECT

INCORRECT

Figure 38. Knife positioning.

FG<I8K@FEJ

-27-