Woodstock W1812 manual @ejkXcc`eGcXe`eBe`m\j,  Disconnect the PLANER/MOULDER from Power

N<8I k_`Zb ^cfm\j Xe[ lj\ \oki\d\ ZXlk`fe n_\e nfib$ `e^ e\Xi Zlkk`e^ jli]XZ\j. GcXe\i be`m\j Xi\ [Xe^\ifljcp j_Xig =X`cli\ kf \o\iZ`j\ ZXi\ n_`c\ nfib`e^ e\Xi be`m\j Zflc[ i\jlck `ej\m\i\`ealip.

Kf`ejkXcck_\gcXe`e^be`m\j#[fk_\j\jk\gj1

(. DISCONNECT THE PLANER/MOULDER FROM POWER!

). Pull the pin shown in =`^li\20, and remove the chip deflector.

*. Put on heavy leather gloves, and use a 14mm wrench to remove the knife bolts, washers, and any knives (if installed).

+. Remove any dust, wood chips, or pitch from the cutterhead where the planing knife will seat.

,. Place the new planer blade against the cutterhead lip with the beveled side of the blade facing up, as shown in =`^li\21.

-. Line up the holes in the planer blade and the cutterhead, and install a 3⁄8"-16 x 1" knife bolt and 3⁄8" flat washer in each of the upper hole positions shown in =`^li\21. Make sure to keep the planer blade seated against the cutterhead lip while tightening the bolts.

.. Visually inspect to make sure that the planer blade did not move away from the cutterhead lip (=`^li\ 22) during the tightening process. If so, reinstall the blade until it is correctly seated.

/. Rotate the cutterhead and install the other planer blade.

Chip

Deflector

FG<I8K@FEJ

0. Set the depth stop (=`^li\19) to maintain planer blade to table clearance.

=`^li\22.Planer knives installed.