Woodstock W1812 manual Jklg

.. Place the belt onto the cutterhead pulley with the belt direction arrow pointing the direction of pulley rotation. When installed correctly, the internal belt tangs must be facing against the pulley rotation arrow shown in =`^li\10.

Pulley

Rotation

Arrow

/. Next, while keeping your fingers clear, lift the motor and roll the belt onto the motor pulley as shown in =`^li\11.

J<KLG

0. Attach the belt guard to the stand (=`^li\12) with two 5⁄16"-18 x 3⁄4" hex bolts, four 5⁄16" flat washers, and two 5⁄16"-18 hex nuts.

('. Slide the handwheel hub over the shaft (=`^li\12) and tighten the set screw with a 5mm hex wrench.

=`^li\10.Installing the drive belt (belt cover removed for clarity).

=`^li\11.Installing the belt guard.

OFF Button

Belt

Guard

=`^li\12.Installing the belt guard and the

handwheel.