Woodstock W1812 manual 8jj\dYcp, KfXjj\dYc\k\gcXe\i&dflc\i#fk\j\jk\gj1

N(/()Fne\ijDXelXcD]^%j`eZ\*&'0

8jj\dYcp

KfXjj\dYc\k_\gcXe\i&dflc[\i#[fk_\j\jk\gj1

(. With the help of an assistant, lay the stand on its side, then insert the 3⁄8" x 16 x 11⁄4" hex bolts through the rubber feet, then thread on a 3⁄8" x 16 hex nut onto each bolt.

). Next, thread each bolt into the reinforced holes shown in =`^li\7, and then thread the four remaining 3⁄8" x 16 hex nuts onto each bolt to lock the feet in place.

Note: For a pre-made heavy-duty mobile base option instead of using the feet, you can place the cabinet directly on the Shop Fox Model D2057 Heavy-Duty Mobile Base equipped with swivel casters and post brakes.

*. Position the stand upright, then adjust the feet so the cabinet sits level on the floor.

+. When level, tighten the jam nuts to lock the feet in place.

,. With the help of an assistant, lift the planer/moulder headstock and position it onto the cabinet, as shown in =`^li\8.

-. Open the cabinet door, then secure the headstock to the cabinet with four 5⁄16"-18 x 3⁄4" hex bolts and 5⁄16" flat washers.

.. Remove the shipping brace shown in =`^li\9.

3⁄8" Diameter

Reinforced

Mounting

Hole

=`^li\7.Foot installation.

=`^li\8.Suggested lifting locations.
	Brace
Shipping	Mounting
	Bolts
Brace
=`^li\9.Shipping brace.

J<KLG

-13-