Woodstock W1683 instruction manual Moving Bed Rollers, To move the bed rollers

Page 18

Moving Bed Rollers

In order to perform table adjustments, the bed rollers must be adjusted below the surface of the table.

To move the bed rollers:

1.Loosen the setscrews where the bed rollers mount to the planer body (on both ends) as shown in Figure 9.

2.Use a wrench to lower the rollers on their eccentric shafts.

Leave the bed rollers in this position until instructed to adjust them at the end of this section.

Table

The most critical adjustments made on your new planer are dependent on the table being parallel to the cutterhead body. Because of this relationship, checking the table is the first step to setting up an accurate planer.

There are two movements you should be concerned about when checking/adjusting the table—the table should be parallel to the head casting from front-to-back, and the table should be parallel with the cutterhead body from side- to-side.

The table has been pre-set at the factory, but it is a good idea to check any machine thoroughly before use.

To check the table:

1.Make sure machine is unplugged!

2.Make the gauge shown in Figure 10 out of a block of wood.

Figure 9. Bed roller setscrews.

Side View

Front View

Figure 10. Gauge block.

14

Image 18
Contents Planer Instruction Sheet Spiral Cutterhead PlanerW1718 Replacement Parts Page Table Of Contents Woodstock Service and Support Introduction About Your NEW PlanerWarranty and Returns Planer Machine SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingKeep proper footing and balance at all times Additional Safety Instructions for Planers Read the manualExtension Cords Electrical Requirements220V Operation GroundingAssembly Box ContentsOverview Shop Preparation Cleaning Machine When assembling, adjusting or operating equipmentExtension Rollers Checking roller extension with a StraightedgeDust Hood To install the dust hoodHandwheel To mount the handwheelTo mount the switch SwitchKnife Setting Jig To assemble the knife setting jigAdjustments Location of ControlsMoving Bed Rollers To move the bed rollersTo check the table Make sure machine is unplugged To adjust the table less than Checking table/head casting in frontTo adjust the table more than Remove the front cabinet coverChecking Knives To check the knivesKnife Adjustment 5 6 4 Feed Rollers, Chip Breaker & Pressure Bar Board position on tableChipbreaker adjustment controls Chip Deflector Anti-Kickback PawlsPlaner. To adjust the roller spring tension Chain TensionerSpring Tension To adjust the table roller height Table RollersTest Run Always Wear Safety Glasses When Operating This machineOperations Feed RateOperational Tips Face joint the concave side of cupped Stock before planingTroubleshooting Planing Results Aftermarket Setup Accessories Planer Pal knife setting jigGeneral MaintenanceCleaning Table And BaseLubrication Worm gearBelt Tension Pulley AlignmentTo align the pulleys Wiring Diagram HP Magnetic Switch -L.Z. TypeTroubleshooting Symptom Possible Cause Corrective ActionClosure 107 100 103 108 101 104 102 8894 109 Headcasting 204 333 334 331 332 Page Middle Table 509 508 540 G8IKJ Warranty Card BOX BELLINGHAM, WA