Woodstock W1683 Checking table/head casting in front, To adjust the table less than

Page 19

Figure 11. Checking table/head casting in front.

Figure 12. Table mounting screws.

3.Place the block on one end of the table, directly under the cutterhead body. Raise the table up so the block only touches the cutterhead body (keep knives rotated out of the way for this step).

4.Without moving the table, slide the block of wood to the other end of the cutterhead. If the block of wood will not fit, or if the block is below the cutterhead body, measure this gap with a feeler gauge. If the difference is more than .002", then the table needs to be adjusted from left to right.

5.Place the block under the front of the head casting, to either side of the depth limiter tab. Raise the table up so the block barely touches the head casting as shown in Figure 11.

6.Remove the block and place it between the middle-rear of the head casting and the table. If there is a gap or it will not fit under the head casting, measure the difference with a feeler gauge. If this measurement is more than .002", then the table needs to be adjusted from front to back.

7.There are two methods to adjust the table on the Model W1683. The first is for adjustments smaller than .016" and the second is for adjustments larger than .016".

To adjust the table less than .016":

1.Use the table mounting screws shown in Figure 12. Loosen the screws and lift/lower the table until the table and the cutterhead body are parallel with each other and the table is parallel with the head casting from front to back. This may require some trial and error.

2.Adjust each column on both sides until the table is properly set. While adjusting the columns, tighten each screw after each step

15

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Planer Spiral Cutterhead Planer Instruction SheetW1718 Replacement Parts Page Table Of Contents Introduction About Your NEW Planer Woodstock Service and SupportPlaner Machine Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstKeep proper footing and balance at all times Read the manual Additional Safety Instructions for PlanersGrounding Electrical Requirements220V Operation Extension CordsBox Contents AssemblyOverview When assembling, adjusting or operating equipment Shop Preparation Cleaning MachineChecking roller extension with a Straightedge Extension RollersTo mount the handwheel To install the dust hoodHandwheel Dust HoodTo assemble the knife setting jig SwitchKnife Setting Jig To mount the switchLocation of Controls AdjustmentsTo move the bed rollers Moving Bed RollersTo check the table Make sure machine is unplugged Checking table/head casting in front To adjust the table less thanRemove the front cabinet cover To adjust the table more thanTo check the knives Checking KnivesKnife Adjustment 5 6 4 Board position on table Feed Rollers, Chip Breaker & Pressure BarChipbreaker adjustment controls Anti-Kickback Pawls Chip DeflectorChain Tensioner Planer. To adjust the roller spring tensionSpring Tension Table Rollers To adjust the table roller heightFeed Rate Always Wear Safety Glasses When Operating This machineOperations Test RunFace joint the concave side of cupped Stock before planing Operational TipsTroubleshooting Planing Results Planer Pal knife setting jig Aftermarket Setup AccessoriesTable And Base MaintenanceCleaning GeneralWorm gear LubricationPulley Alignment Belt TensionTo align the pulleys HP Magnetic Switch -L.Z. Type Wiring DiagramSymptom Possible Cause Corrective Action TroubleshootingClosure 107 100 103 108 101 104 102 8894 109 Headcasting 204 333 334 331 332 Page Middle Table 509 508 540 G8IKJ Warranty Card BOX BELLINGHAM, WA
Top Page Image Contents