Woodstock W1683 Handwheel, Dust Hood, To mount the handwheel, To install the dust hood

Page 15

Figure 4. Handwheel attached correctly.

Figure 5. Dust hood attached to planer.

Handwheel

The handwheel operates the chain driven system that raises/lowers the table to control the cutting depth.

To mount the handwheel:

1.Secure the handwheel to the worm gear shaft (as shown in Figure 4) with the hex nut and washer that is already on the threads.

2.Thread the handle into the handwheel and tighten the hex nut to keep it locked in place.

Dust Hood

The dust hood included should only be installed if you plan on hooking your planer up to a dust collection system.

To install the dust hood:

1.Match the holes in the dust hood to the tapped holes in the planer casting on the outfeed end.

2.Secure the dust hood with the (6) M6-1.0 x 12 hex bolts from the hardware bag, as shown in Figure 5.

3.Attach a 5" dust hose to the dust port.

11

Image 15

Contents Planer Spiral Cutterhead Planer Instruction SheetW1718 Replacement Parts Page Table Of Contents Introduction About Your NEW Planer Woodstock Service and SupportPlaner Machine Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstKeep proper footing and balance at all times Read the manual Additional Safety Instructions for PlanersGrounding Electrical Requirements220V Operation Extension CordsAssembly Box ContentsOverview When assembling, adjusting or operating equipment Shop Preparation Cleaning MachineChecking roller extension with a Straightedge Extension RollersTo mount the handwheel To install the dust hoodHandwheel Dust HoodTo assemble the knife setting jig SwitchKnife Setting Jig To mount the switchLocation of Controls AdjustmentsMoving Bed Rollers To move the bed rollersTo check the table Make sure machine is unplugged Checking table/head casting in front To adjust the table less thanRemove the front cabinet cover To adjust the table more thanTo check the knives Checking KnivesKnife Adjustment 5 6 4 Board position on table Feed Rollers, Chip Breaker & Pressure BarChipbreaker adjustment controls Anti-Kickback Pawls Chip DeflectorPlaner. To adjust the roller spring tension Chain TensionerSpring Tension Table Rollers To adjust the table roller heightFeed Rate Always Wear Safety Glasses When Operating This machineOperations Test RunFace joint the concave side of cupped Stock before planing Operational TipsTroubleshooting Planing Results Planer Pal knife setting jig Aftermarket Setup AccessoriesTable And Base MaintenanceCleaning GeneralWorm gear LubricationBelt Tension Pulley AlignmentTo align the pulleys HP Magnetic Switch -L.Z. Type Wiring DiagramSymptom Possible Cause Corrective Action TroubleshootingClosure 107 100 103 108 101 104 102 8894 109 Headcasting 204 333 334 331 332 Page Middle Table 509 508 540 G8IKJ Warranty Card BOX BELLINGHAM, WA