Woodstock W1683 instruction manual Operations, Test Run, Feed Rate

Page 29

Operations

Always

wear

safety

glasses

when

operating

this machine!

 

Test Run

Before turning the machine on for the first time, make sure you have read through the entire manual and have performed the instructions given in the Assembly and Adjustments sections.

DO NOT investigate problems or adjust the planer while it is running or plugged into power!

Figure 30. Feed rate knob.

Figure 31. Feed rate knob positions.

NOTICE

DO NOT change speeds while planing or severe damage to gearbox will result!

Once assembly and adjustments have been properly performed, the machine is ready to be connected to the power. Make sure there are no obvious safety hazards and any tools used to assemble/adjust the machine are properly cleared away. The table should be lowered enough to provide plenty of room for the safe operation of the feed rollers and the cutterhead.

Press the START button. Make sure that you remain near the switch in case you have to press the STOP button in an emergency. Strange or unnatural noises should be investigated and corrected before operating the machine further.

Feed Rate

The feed rate is the speed that the rollers drive the workpiece through the planer. The Model W1683 features 18 and 23 F.P.M. feed rates.

As a general rule, the faster feed rate will dimension lumber quicker but leave a rougher finish; the slower feed rate will have the opposite effect and leave a smoother finish. Often, a small amount of trial-and-error will be the best way to determine which setting is right for your particular application.

To change the feed roller speed, locate the feed rate knob shown in Figure 30. The machine must be running in order to change speeds; however, you should NEVER be planing stock through the machine when you switch speeds. Start the planer and adjust the knob as illustrated in Figure 31.

25

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Planer Spiral Cutterhead Planer Instruction SheetW1718 Replacement Parts Page Table Of Contents Introduction About Your NEW Planer Woodstock Service and SupportPlaner Machine Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstKeep proper footing and balance at all times Read the manual Additional Safety Instructions for Planers220V Operation Electrical RequirementsExtension Cords GroundingOverview AssemblyBox Contents When assembling, adjusting or operating equipment Shop Preparation Cleaning MachineChecking roller extension with a Straightedge Extension RollersHandwheel To install the dust hoodDust Hood To mount the handwheelKnife Setting Jig SwitchTo mount the switch To assemble the knife setting jigLocation of Controls AdjustmentsTo check the table Make sure machine is unplugged Moving Bed RollersTo move the bed rollers Checking table/head casting in front To adjust the table less thanRemove the front cabinet cover To adjust the table more thanTo check the knives Checking KnivesKnife Adjustment 5 6 4 Board position on table Feed Rollers, Chip Breaker & Pressure BarChipbreaker adjustment controls Anti-Kickback Pawls Chip DeflectorSpring Tension Planer. To adjust the roller spring tensionChain Tensioner Table Rollers To adjust the table roller heightOperations Always Wear Safety Glasses When Operating This machineTest Run Feed RateFace joint the concave side of cupped Stock before planing Operational TipsTroubleshooting Planing Results Planer Pal knife setting jig Aftermarket Setup AccessoriesCleaning MaintenanceGeneral Table And BaseWorm gear LubricationTo align the pulleys Belt TensionPulley Alignment HP Magnetic Switch -L.Z. Type Wiring DiagramSymptom Possible Cause Corrective Action TroubleshootingClosure 107 100 103 108 101 104 102 8894 109 Headcasting 204 333 334 331 332 Page Middle Table 509 508 540 G8IKJ Warranty Card BOX BELLINGHAM, WA
Top Page Image Contents