Woodstock W1683 Extension Rollers, Checking roller extension with a Straightedge

Page 14

Extension Rollers

The extension roller assemblies are identical for both the infeed and the outfeed ends of the table. To mount these assemblies:

1.Attach an extension bar to the end of each roller. Secure these in place with the 12mm snap rings provided in the hardware bag.

2.Match the tapped holes on the side of the table to the extension bars. Lightly secure in place with the M10-1.5 x 25 hex bolts and washers from the hardware bag.

3.The end (outside) roller is fixed in place. Place a straightedge flat across the table and across the rollers as shown in Figure 3. Adjust the end roller so it is flush with the table, and tighten the M10-1.5 x 25 hex bolts to secure the extension bars in place.

4.The two inside rollers are mounted in slotted holes so they can be adjusted flush with the table and the end roller. Make these adjustments and tighten the bolts to secure the inside rollers in place.

The top of the rollers should now be completely even with the top of the table. Double-check to make sure that the rollers did not move during the tightening process.

Figure 3. Checking roller extension with a

straightedge.

10

Image 14

Contents Planer Instruction Sheet Spiral Cutterhead PlanerW1718 Replacement Parts Page Table Of Contents Woodstock Service and Support Introduction About Your NEW PlanerWarranty and Returns Planer Machine SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingKeep proper footing and balance at all times Additional Safety Instructions for Planers Read the manualExtension Cords Electrical Requirements220V Operation GroundingOverview AssemblyBox Contents Shop Preparation Cleaning Machine When assembling, adjusting or operating equipmentExtension Rollers Checking roller extension with a StraightedgeDust Hood To install the dust hoodHandwheel To mount the handwheelTo mount the switch SwitchKnife Setting Jig To assemble the knife setting jigAdjustments Location of ControlsTo check the table Make sure machine is unplugged Moving Bed RollersTo move the bed rollers To adjust the table less than Checking table/head casting in frontTo adjust the table more than Remove the front cabinet coverChecking Knives To check the knivesKnife Adjustment 5 6 4 Feed Rollers, Chip Breaker & Pressure Bar Board position on tableChipbreaker adjustment controls Chip Deflector Anti-Kickback PawlsSpring Tension Planer. To adjust the roller spring tensionChain Tensioner To adjust the table roller height Table RollersTest Run Always Wear Safety Glasses When Operating This machineOperations Feed RateOperational Tips Face joint the concave side of cupped Stock before planingTroubleshooting Planing Results Aftermarket Setup Accessories Planer Pal knife setting jigGeneral MaintenanceCleaning Table And BaseLubrication Worm gearTo align the pulleys Belt TensionPulley Alignment Wiring Diagram HP Magnetic Switch -L.Z. TypeTroubleshooting Symptom Possible Cause Corrective ActionClosure 107 100 103 108 101 104 102 8894 109 Headcasting 204 333 334 331 332 Page Middle Table 509 508 540 G8IKJ Warranty Card BOX BELLINGHAM, WA