Omron ZS-MDC user manual Setting I/O Assignments, Switching banks by external signal input

Section 3 SETUP

Section 3

Setting I/O Assignments

Setting I/O Assignments

Switching banks by external signal input

Set the task or function to the external input.

If you use SmartMonitor Zero, you can change the function assignments of IN2 and IN3 if [BANK] is selected. For details, refer to the Help for SmartMonitor Zero.

▲FUN mode-[I/O SET]-[I/O SET]-[IN]
	Setting			Description
TASK		Select to task for enabling the external signal lead. Note, however, that reset input
		and bank inputs affects tasks at all times.
		Range: TASK1 to TASK4, TASK-ALL
FUNC	NORMAL	Select this to use external input function as in standard applications so far (default
		value).
		IN0	IN1		IN2	IN3
		External trigger	Reset input		Unused	Zero reset input
		(timing) input
	BANK	Select this to switch banks using external inputs.
		IN0	IN1		IN2	IN3
		Bank input A	Bank input B		Unused	Zero reset input

For bank inputs A and B, the bank can be selected in the following combinations.

Bank to be Selected	Bank input A	Bank input B
BANK1	OFF	OFF
BANK2	OFF	ON
BANK3	ON	OFF
BANK4	ON	ON

•Bank switching is begun 0.5 seconds after the input state changes.

•At most it takes about 10 seconds to switch banks.

•During bank switching the BUSY output becomes ON.

3-16

ZS-MDC

User’s Manual