Omron ZS-MDC user manual Editors Note, Format

Introduction

Introduction

Editor's Note

Editor's Note

Page Format

Section 3

Setting the Sensor Controller to Obtain Sensing Information from

Setting the Sensor Controller to Obtain Sensing Information from

Set which gang-mounted Sensor Controller to obtain information from, and which logic operations are to be performed on that information.

Setting Assignments

Assign the channel to perform logic operation on.

FUNMode-[SENSING]-[SEL CH ]		Section
Setting	Description
INPUT A (input A)	Assigns the target Sensor Controller to input A.	3
	Range: None, 1CH onwards (largest CH of gang-mounted Sensor Controllers)
		SETUP
	(default: 1CH. Note that range becomes “None” if 1CH does not exist.)
INPUT B (input B)	Assigns the target Sensor Controller to input B.
	Range: None, 1CH onwards (largest CH of gang-mounted Sensor Controllers)
	(default: 2CH. Note that range becomes “None” if 2CH does not exist.)
INPUT C (input C)	Assigns the target Sensor Controller to input C.
	Range: None, 1CH onwards (largest CH of gang-mounted Sensor Controllers)
	(default: 3CH. Note that range becomes“None” if 3CH does not exist.)
INPUT D (input D)	Assigns the target Sensor Controller to input D.
	Range: None, 1CH onwards (largest CH of gang-mounted Sensor Controllers)
	(default: 4CH. Note that range becomes “None” if 4CH does not exist.)

Setting Logic Operation Methods

Set how logic operations are to be performed on the tasks and CH specified by the assignment settings.

FUNMODE-[SENSING]-[CALC]

Setting	Description
OFF	Expressions are not set.
CH	Logic operations are not performed, and the measured value of a specific CH
	is input as it is.Select the target CH.

Title of each section

Header

Overview

Cross-header

Overview of the cross-header

Index label

Indicates the section number and title.

Movement through menus up to setting items

Explanation of options

Inputs do not undergo logical operation when “None” is set. Example: The operation “-B” is per- formed when “None” is set to input A, “3CH” is assigned to input B and A-B is selected.

ZS-MDC

User’s Manual 3-15

Supplementary Explanation

Helpful information regarding operation and reference pages are introduced here using symbols.

*This page has been made purely for explanatory purposes and does not exist.

8

ZS-MDC

User’s Manual