3.adjust the hex nuts on the motor mount bolts (see Figure 135) until there is approximately 3⁄4" deflection in each
Motor Mount
Hex Nuts & Bolts
Pulley
Deflection
3⁄4"
Pulley
Figure 135. Adjusting V-belt tension.
4.Firmly tighten the hex nuts to secure the set- ting, then re-install the motor access panel and close the end-gear cover.
Replacing |
|
Tools Needed: | Qty |
Slotted Screwdriver #2 | 1 |
Open End Wrench 10mm | 1 |
1.disCONNECT LATHE FROM POWER!
2.Open the
3.adjust the hex nuts on the motor mount bolts (see Figure 135 to raise the motor, then remove the
4.Install the new
5.Tension the
6.
Model G0746/G0749 (Mfg. Since 3/13)