Grizzly G9972Z owner manual Configuring the V-Belt, To configure the V-belt, YaZgEjaaZn K7Zai

6	&*%	(%%	*+%	,'% &'%% ')%%
7
	78&	78'	78(	68&	68'	68(
8
&'(	Figure 36.BdYZa<.,,'Ohe^cYaZheZZYK"WZaiXdc[^\jgVi^dcX]Vgi#

The V-belt, change gears, and pulleys represent a serious entanglement hazard when the lathe is running. Always dis- connect the lathe from power before opening the change gear cover.

Configuring the V-Belt

I]ZgZ VgZ h^m he^cYaZ heZZYh VkV^aVWaZ Wn egde" Zganedh^i^dc^c\i]ZK"WZaidci]Zbdidg!^YaZg!VcY he^cYaZejaaZnh#

Tools NeededQty

LgZcX]&,bb#################################################### &

To configure the V-belt:

1. 9>H8DCC:8IA6I=:;GDBEDL:G

2. GZ[Zg id i]Z X]Vgi ^c Figure 36 VWdkZ VcY [^cYi]Zhe^cYaZheZZYdci]Zidegdli]Vi^h XadhZhiidndjgXVaXjaViZYhe^cYaZheZZY#

Note: This chart is also on the front of the headstock. In most cases, the calculated spindle speed will be between the available speeds. Use your best judgement when choosing either a higher or lower spindle speed.

3. JhZ Figures 37–38 id ^YZci^[n i]Z 6! 7! VcY8ejaaZnh#6ahd!cdiZi]ZadXVi^dcd[i]Z ^YaZgejaaZn#

>YaZgEjaaZn

8

6

K"7Zai

Figure 37.K"WZai^ci]Z6¶8Xdc[^\jgVi^dc#

>YaZgEjaaZn 6Y_jhibZci HijYCji

8

7

K"7Zai

Figure 38.K"WZai^ci]Z7¶8Xdc[^\jgVi^dc#

Note: There is hex nut on either end of the idler pulley adjustment stud that is loosened when adjusting the idler pulley.

"(%" <..,'O&&m'+AVi]Zl$<ZVgWdm