Black & Decker BDTS200, 90528116 instruction manual Attaching Miter Gauge Holder

ATTACHING MITER GAUGE HOLDER

WARNING: DISCONNECT MACHINE FROM POWER SOURCE.

E

F

A

B

G

Fig. 5

Fig. 6

1.Attach the spring clip (E) Fig. 5 to the miter gauge holder (A) using an M4x.7x10mm pan head screw (F), 3/16 inch external tooth lockwasher, (B) and M4x.7 hex nut.

NOTE: The hex nut (G) Fig. 6 will fit into the recess at the back of the miter gauge holder (A) Fig. 5 to keep the spring clip (E) secured to the miter gauge holder.

2.Attach the miter gauge holder (A) Fig. 7 to the left side of the saw cabinet using the four M4x.2x10mm screws (B) Fig. 8, and 3/16 inch flat washers (C) from inside of the saw cabinet.

3.Fig. 9 illustrates the miter gauge (D) inserted into the holder.

A

Fig. 7

C

B

Fig. 8

D

A

B

Fig. 9

Fig. 10

MITER GAUGE

The miter gauge is shipped assembled and is supplied with a T-slot bar (A) Fig. 10 that is inserted into either one of the two T-slotted miter gauge grooves (B) located in the table top. The T-slot prevents the miter gauge from falling when it is extended beyond the front of the table when cross-cutting extra wide workpieces.

10