Cisco Systems NME-WAE manual Contents

Page 1

Configuring Cisco Access Routers and the

NME-WAE Network Module for ACNS

Deployments

April 14, 2008

This document describes how to configure the Cisco access router and the Cisco Wide Area Application Engine network module (NME-WAE) for Application and Content Networking System (ACNS) software deployments.

The WAE network module is a standalone Wide Area Application Engine (WAE) that plugs into a host Cisco access router. The host router runs Cisco IOS software, while the WAE network module has its own startup and run-time configurations that are independent of the IOS configuration on the router.

ACNS software is a Linux-based application that resides on the WAE network module. ACNS software offers the following content-based services:

•Content caching and hosting

•Proxy services

•Content replication

•Video streaming

The host router and the network module combined provide a router-integrated application platform for accelerating data-intensive applications.

Contents

•Prerequisites for Installing the Cisco WAE Network Modules, page 2

•Restrictions for Cisco WAE Network Modules, page 2

•Cisco WAE Network Module Hardware Description, page 3

•Setting Up Cisco WAE Network Modules and Opening a Session, page 5

•Starting the Cisco WAE Network Module and Displaying Status, page 10

•Command Reference, page 15

Americas Headquarters:

Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA

© 2007-2008 Cisco Systems, Inc. All rights reserved.

Image 1

Contents Contents Restrictions for Cisco WAE Network Modules Prerequisites for Installing the Cisco WAE Network ModulesCisco WAE Network Module Hardware Description Hard Disk and Memory SpecificationsFaceplate and LEDs Model Hard Disk MemoryCF card ShutdownOn This Hardware Interface Configure These Settings Using ThisHardware Interfaces This section contains the following topicsSummary Steps Detailed Steps Examples Setting Up Network Module InterfacesExample Procedure CommandDisplay the router running configuration so that you can Save the router running configurationVerify interface configurations Opening and Closing a Network Module SessionPress Control-Shift-6 Press Ctrl-Shift-6 Example ConfigurationConfiguration Mode Command Purpose Accessing the Acns Software on the Network ModuleShutting Down and Starting Up Cisco WAE Network Modules Displaying Status and Diagnostic Output Command Purpose Cisco technical support for problem Service module. This information is useful toDisplays general information about DiagnosisCommand Reference Interface integrated-service-engine slot/unit Interface integrated-service-engineSyntax Description Defaults Command Modes Command History ReleaseModificationDefaults Command Modes Command History Service-module integrated-service-engine default-bootBootloader to perform startup routines None Privileged ExecService-module integrated-service-engine slot/unit reload Service-module integrated-service-engine reloadCommand Description Usage GuidelinesService-module integrated-service-engine slot/unit reset Service-module integrated-service-engine resetRelated Commands Description Router# service-module integrated-service-engine 1/0 resetCommand Description Open Service-module integrated-service-engine sessionUsername Related Commands Description Service-module integrated-service-engine slot/unit shutdown Service-module integrated-service-engine shutdownInterface integrated-service-engine Integrated-service-engine resetCommand Description Access router Service-module integrated-service-engine statisticsService-module integrated-service-engine slot/unit status Service-module integrated-service-engine statusRouter# service-module integrated-service-engine 1/0 status Display the ISE network module software release versionRelated Commands Description Show controllers integrated-service-engine slot/unit Show controllers integrated-service-engineField Description Related Commands Description Show diag slot Show diagRelease Modification Show diag subslot Field Descriptions Integrated-service-engine network modules Displays basic interface configuration information forNetwork modules Show interfaces integrated-service-engine slot/unit Show interfaces integrated-service-engineCommand Modes Command History Field Description Station that is transmitting bad data Errors created when the CRC generated by the originating LANField Description Bootloader BoothelperGlossary BladeRelated Documentation Service or servicesEngine Syslog Related Topic Document TitlePage OL-13140-02