Cisco Systems NME-WAE manual Service-module integrated-service-engine session, Open, Username

service-module integrated-service-engine session

service-module integrated-service-engine session

To begin a configuration session with an integrated-service-engine (ISE) network module through a console connection, use the service-moduleintegrated-service-engine session command in privileged EXEC mode.

service-module integrated-service-engine slot/unit session [clear]

Syntax Description

Defaults

Command Modes

Command History

Usage Guidelines

slot	Slot number of the network module in the router chassis.
/unit	Number of the daughter card on the network module. For ISE network
	modules, always use 0. The slash mark (/) is required between the slot
	argument and the unit argument.
clear	(Optional) Clears the ISE configuration session.
None
Privileged EXEC

ReleaseModification

12.4(9)T This command was introduced for ISE network modules.

Only one session at a time is allowed into the network module from the internal ISE network-module-side interface.

After starting a session, access the ISE console in a user-level shell. To access the privileged EXEC command shell, where most commands are available, use the enable command.

After you finish the ISE configuration and exit the ISE console session, use this command with the clear keyword to clear the session. At the confirmation prompt, press Enter to confirm the action or n to cancel.

Examples	The following example shows an ISE session being opened for an ISE network module in slot 2:
	Router# service-module integrated-service-engine 2/0 session
	Trying 10.10.10.1, 2066 ...	Open
	Cisco Content Engine Console
	Username:

Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments

OL-13140-02 21