Cisco Systems NME-WAE manual Field Description

show interfaces integrated-service-engine

		Table 6	show interfaces integrated-service-engine Field Descriptions (continued)
		Field		Description
		rxload		Receive load on the interface as a fraction of 255 (255/255 is
				completely saturated), calculated as an exponential average over
				5 minutes.
		Encapsulation		Encapsulation method that is assigned to the interface, ARPA in
				this case.
		loopback		Indicates whether loopback is set.
		Keepalive		Indicates whether keepalives are set and the interval between
				keepalives if they have been set.
		Full-duplex		Indicates either full-duplex or half-duplex mode and other link
				configuration details.
		ARP type Timeout		Type of Address Resolution Protocol (ARP) assigned and length
				of timeout.
		Last input		Number of hours, minutes, and seconds since the last packet was
				successfully received by the interface and processed locally on
				the router. This field is useful for detecting when an interface
				failed.
				This field is not updated by fast-switched traffic.
		output		Number of hours, minutes, and seconds since the last packet was
				successfully transmitted by the interface. This field is useful for
				detecting when an interface failed.
		output hang		Number of hours, minutes, and seconds (or never) since the
				interface was last reset because a transmission took too long.
				When the number of hours in any of the “last” fields exceeds
				24 hours, the number of days and hours is printed. If that field
				overflows, asterisks are printed.
		Last clearing		Elapsed time since the counters that measure cumulative statistics
				(such as number of bytes transmitted and received) shown in this
				report were last reset to zero. Variables that may affect routing
				(for example, load and reliability) are not cleared when the
				counters are cleared.
				Asterisks (***) indicate that the elapsed time is too large to be
				displayed.
		Input queue		Number of packets in the input queue. A slash separates the
				following values that indicate the maximum size of the queue, the
				number of packets dropped because of a full queue, and the
				number of times that queued packets have been discarded.
		Total output drops		Number of packets in the output queue that have been dropped
				because of a full queue.
		Queueing strategy		Queuing strategy applied to the interface, which is configurable
				under the interface. The default is FIFO.
		Output queue		Number of packets in the output queue. A slash separates the
				following values that indicate the maximum size of the queue and
				the number of packets dropped because of a full queue.
	Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments
34				OL-13140-02