Cisco Systems NME-WAE manual Errors created when the CRC generated by the originating LAN

			show interfaces integrated-service-engine
	Table 6	show interfaces integrated-service-engine Field Descriptions (continued)
	Field		Description
	5 minute input rate,		Average number of bits and packets transmitted per second in the
	5 minute output rate		last 5 minutes. If the interface is not in promiscuous mode, it
			senses network traffic that it sends and receives (rather than all
			network traffic).
			The 5-minute input and output rates should be used only as an
			approximation of traffic per second during a given 5-minute
			period. These rates are exponentially weighted averages with a
			time constant of 5 minutes. A period of four time constants must
			pass before the average will be within 2 percent of the
			instantaneous rate of a uniform stream of traffic over that period.
			Note The 5-minute period referenced in this output is a load
			interval that is configurable under the interface. The
			default value is 5 minutes.
	packets input		Total number of error-free packets received by the system.
	bytes		Total number of bytes, including data and MAC encapsulation, in
			the error-free packets received by the system.
	no buffer		Number of received packets discarded because there was no
			buffer space. Ignored Broadcast storms on Ethernet and bursts of
			noise on serial lines are often responsible for no input buffer
			events.
	Received broadcasts		Number of broadcasts received.
	runts		Number of packets that are discarded because they are smaller
			than the minimum packet size of the medium. For instance, any
			Ethernet packet that is less than 64 bytes is considered a runt.
	giants		Number of packets that are discarded because they exceed the
			maximum packet size of the medium. For example, any Ethernet
			packet that is greater than 1518 bytes is considered a giant.
	throttles		Number of times that the interface requested another interface
			within the router to slow down.
	input errors		Errors that include runts, giants, no buffer, cyclic redundancy
			check (CRC), frame, overrun, and ignored counts. Other
			input-related errors can also cause the input errors count to be
			increased, and some datagrams may have more than one error;
			therefore, this sum may not balance with the sum of enumerated
			input error counts.
	CRC		Errors created when the CRC generated by the originating LAN
			station or far-end device does not match the checksum calculated
			from the data received. On a LAN, such errors usually indicate
			noise or transmission problems on the LAN interface or the LAN
			bus. A high number of CRCs is usually the result of collisions or
			a station that is transmitting bad data.
	frame		Number of packets received incorrectly that have a CRC error and
			a non-integer number of octets. On a LAN, this error is usually the
			result of collisions or a malfunctioning Ethernet device.
		Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments
OL-13140-02				35