Cisco Systems NME-WAE manual Interface integrated-service-engine, ReleaseModification, Examples

Page 16

interface integrated-service-engine

interface integrated-service-engine

To enter the interface configuration mode for an integrated-service-engine (ISE) network module, use the interface integrated-service-enginecommand in global configuration mode.

interface integrated-service-engine slot/unit

Syntax Description

Defaults

Command Modes

Command History

slot	Slot number of the interface.

unit	Number of the daughter card on the network module. For ISE network
	modules, always use 0.

None

Global configuration

ReleaseModification

12.4(9)T	This command was introduced for ISE network modules.

Usage Guidelines This command is used only for ISE network modules. If your router does not have this hardware, then you will not be able to enter this command.

Ano form of this command (no interface integrated-service-engine) is not available. Use the exit command to exit the interface configuration mode.

Examples	The following example shows how to enter configuration mode for ISE network modules located in slot
	1, unit 0:
	Router	(config)# interface integrated-service-engine 1/0
	Router	(config-if)# exit

Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments

16	OL-13140-02

Image 16

Contents Contents Prerequisites for Installing the Cisco WAE Network Modules Restrictions for Cisco WAE Network ModulesHard Disk and Memory Specifications Cisco WAE Network Module Hardware DescriptionFaceplate and LEDs Model Hard Disk MemoryShutdown CF cardUsing This On This Hardware Interface Configure These SettingsHardware Interfaces This section contains the following topicsSetting Up Network Module Interfaces Summary Steps Detailed Steps ExamplesProcedure Command ExampleSave the router running configuration Display the router running configuration so that you canVerify interface configurations Opening and Closing a Network Module SessionPress Control-Shift-6 Example Configuration Press Ctrl-Shift-6Configuration Mode Command Purpose Accessing the Acns Software on the Network ModuleShutting Down and Starting Up Cisco WAE Network Modules Displaying Status and Diagnostic Output Command Purpose Service module. This information is useful to Cisco technical support for problemDisplays general information about DiagnosisCommand Reference Interface integrated-service-engine Interface integrated-service-engine slot/unitSyntax Description Defaults Command Modes Command History ReleaseModificationService-module integrated-service-engine default-boot Defaults Command Modes Command HistoryBootloader to perform startup routines None Privileged ExecService-module integrated-service-engine reload Service-module integrated-service-engine slot/unit reloadCommand Description Usage GuidelinesService-module integrated-service-engine reset Service-module integrated-service-engine slot/unit resetRelated Commands Description Router# service-module integrated-service-engine 1/0 resetCommand Description Open Service-module integrated-service-engine sessionUsername Related Commands Description Service-module integrated-service-engine shutdown Service-module integrated-service-engine slot/unit shutdownInterface integrated-service-engine Integrated-service-engine resetCommand Description Service-module integrated-service-engine statistics Access routerService-module integrated-service-engine status Service-module integrated-service-engine slot/unit statusRouter# service-module integrated-service-engine 1/0 status Display the ISE network module software release versionRelated Commands Description Show controllers integrated-service-engine slot/unit Show controllers integrated-service-engineField Description Related Commands Description Show diag slot Show diagRelease Modification Show diag subslot Field Descriptions Integrated-service-engine network modules Displays basic interface configuration information forNetwork modules Show interfaces integrated-service-engine slot/unit Show interfaces integrated-service-engineCommand Modes Command History Field Description Errors created when the CRC generated by the originating LAN Station that is transmitting bad dataField Description Boothelper BootloaderGlossary BladeService or services Related DocumentationEngine Syslog Related Topic Document TitlePage OL-13140-02