Cisco Systems NME-WAE manual Cisco WAE Network Module Hardware Description, Faceplate and LEDs

Cisco WAE Network Module Hardware Description

Because the network module does not have an external console port, you must configure the network module by initiating a Telnet session or by initiating a configuration session from the router CLI.

•After initial setup, which requires using router configuration commands, you can configure the NME-WAE in the same manner as other ACNS devices, with the following exceptions:

–The NME-WAE cannot serve as a Content Distribution Manager for other ACNS devices.

–The NME-WAE does not support device mode configuration. The device mode configuration prompt has been removed from the NME-WAE startup script.

–Websense URL-filtering is not supported on the NME-WAE.

•ACNS software does not support the following hardware-related features on the network module:

–USB port

–Compact Flash utilization LED

–Software reset button

Cisco WAE Network Module Hardware Description

This section includes the following topics describing the WAE network module hardware:

•Hard Disk and Memory Specifications

•Faceplate and LEDs

•Hardware Interfaces

Hard Disk and Memory Specifications

The NME-WAE ships from the factory with the hardware listed in Table 1 preinstalled.

Table 1	Network Module Hardware
Model		Hard Disk	Memory
NME-WAE-502-K9		120 GB	1 GB
NME-WAE-522-K9		160 GB	2 GB

Faceplate and LEDs

Figure 1 shows the NME-WAE faceplate and LEDs.

Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments

OL-13140-02 3