Cisco Systems NME-WAE manual Show controllers integrated-service-engine, Field Description

show controllers integrated-service-engine

show controllers integrated-service-engine

To display controller information for integrated-service-engine (ISE) network modules, use the show controllers integrated-service-enginecommand in privileged EXEC mode.

show controllers integrated-service-engine slot/unit

Syntax Description	slot	Slot number of the network module in the router chassis.
	/unit	Number of the daughter card on the network module. For ISE network
		modules, always use 0. The slash mark (/) is required between the slot
		argument and the unit argument.

Defaults

Command Modes

Command History

None

Privileged EXEC

ReleaseModification

12.4(9)T This command was introduced for ISE network modules.

Examples	Table 4 describes the fields shown in the command output.
	Table 4	show controllers integrated-service-engine Field Descriptions
	Field		Description
	Hardware		Description of the chip being used.
	IDB, FASTSEND		Address in router memory of the interface descriptor block (IDB)
			and the fastsend routine.
	INSTANCE		Device-specific data stored in router memory that lists the
			memory locations and current indexes of receive (Rx) and
			transmit (Tx) rings in the router I/O memory.
	CONTROL AND STATUS		Control and status registers that are physically located on the chip
	REGISTERS (CSR)		itself and that are accessed by the CPU over the protocol control
			information (PCI) bus.
	PHY REGISTERS		Contents of the physical layer (PHY) registers. A PHY module is
			a device that interfaces to the physical Ethernet line and that is
			located between the chip and the physical line.
	HARDWARE STATISTICS		Receive (Rx) and transmit (Tx) traffic statistics collected by the
			chip.
	INTERRUPT STATISTICS		Transmit (Tx), Receive (Rx), control, software, and flow control
			interrupt statistics collected by the chip.

Configuring Cisco Access Routers and the NME-WAE Network Module for ACNS Deployments

28 OL-13140-02