Graco 16N654, 16H960, 16N655 Install/Service Filter if needed, Perform Pressure Relief Procedure

Page 13

Operation

7.Reverse tip to UNCLOG position. Put prime/pres- sure relief valve DOWN to spray position and trigger sprayer through tip into waste area for 1- 2 seconds.

ti19370a ti19346a

ti19366a

8.Engage trigger lock and put prime/pressure relief valve UP to release pressure.

ti19347a

ti19350a

9.Remove material cup.

10.Disengage trigger lock, put prime/pressure relief valve DOWN to spray position, hold sprayer slightly above material cup and pull trigger to discharge fluid from pump.

ti19403a

11.Put prime/pressure relief valve UP and pull trigger to finish flushing material.

ti19401a

12. Properly discard any material in cup.

Install/Service Filter (if needed)

1.Perform Pressure Relief Procedure, page 9.

2.Unthread front valve housing from sprayer.

ti19362a

3.Filter should come out of pump housing with valve. If filter remains in housing, remove it by hand or with pliers if necessary.

ti19342a

4. Install properly-sized filter (if needed).

ti19349a

5. Reassemble valve housing to pump.

ti19364a

3A2308C

13

Image 13

Contents Model Protective Coating Hand-Held Paint Sprayer 3A2308CTable of Contents Grounding Instructions Skin Injection Hazard Charger Electric SHOCK, Fire and Explosion Hazard Description Component IdentificationCharger Status Indicator Lights Charging the BatteryOperation Sprayer Status Indicator Trigger Locked Common ProceduresTrigger Unlocked red ring is visible Adjusting Pressure Ti19655a Ti19656a Ti19654a Ti19653a Starting a New Job SetupSee Grounding Instructions, Perform Pressure Relief Procedure, Install/Service Filter if neededFilling and Installing Cup Install Tip/Guard Assembly if not installedPriming Pump Setting PressureTi19655a Ti19656a Ti19654a Ti19653a Triggering Sprayer Getting Started with Basic TechniquesAiming Sprayer Pulsating MaterialUnclogging Spray Tip/Guard Assembly Flushing Sprayer Shutdown and CleaningRemove cup and properly dispose contaminated fluid Storage Cleaning Sprayer ExteriorParts Part Description Qty Parts ListInstall/Service Filter, TroubleshootingRemoved. See Install/Service Filter Job or Refilling the Cup,See Charging the Battery, Spray Pattern Diagnostics See Shutdown and Cleaning, Inlet Valve RepairOutlet Valve Pressure Control Knob Pump Module/Drive Module Pump Rebuild Kit Clamshell Route wires from motor down the handle Motor/Control Board Replacement Kit Ti19632a Ti19641a Switch Assembly Install trigger lock over trigger with o-ring facing out Gear Replacement Ti19857a Ti19860a FCC Declaration for Battery Charger Technical DataMetric 3A2308C 3A2308C Graco Information Graco Standard Warranty