Graco 16H960, 16N655, 16N927, 16N654, 16N656 important safety instructions Pressure Control Knob

Page 30

Pressure Control Knob

Removal

1.Engage trigger lock and put prime/pressure relief valve in UP position to relieve pressure.

ti19347a ti19350a

2.Loosen two set screws (34) from pressure control knob and remove knob.

34

ti19620a

Repair

Installation

NOTE: Inlet valve must be fully installed before outlet valve can be installed.

1.Make sure prime/pressure relief valve is in UP posi- tion. Use a thin screwdriver or allen wrench to turn outlet valve counter-clockwise until it touches inlet ball. DO NOT TIGHTEN. Outlet valve should only be threaded until inlet ball does not move when touched.

ti19347a

ti19616a

2.Install pressure control knob. Turn knob fully coun- ter-clockwise (“0” setting will line up with red dot). Torque set screws (34) to 40 in-lb (4.5 N•m).

34

ti19620a

ti19351a

30

3A2308C

Image 30

Contents Protective Coating Hand-Held Paint Sprayer 3A2308C ModelTable of Contents Grounding Instructions Skin Injection Hazard Charger Electric SHOCK, Fire and Explosion Hazard Component Identification DescriptionCharging the Battery Charger Status Indicator LightsOperation Sprayer Status Indicator Common Procedures Trigger LockedTrigger Unlocked red ring is visible Adjusting Pressure Ti19655a Ti19656a Ti19654a Ti19653a Setup Starting a New JobSee Grounding Instructions, Install/Service Filter if needed Perform Pressure Relief Procedure,Install Tip/Guard Assembly if not installed Filling and Installing CupSetting Pressure Priming PumpTi19655a Ti19656a Ti19654a Ti19653a Aiming Sprayer Getting Started with Basic TechniquesTriggering Sprayer Pulsating MaterialUnclogging Spray Tip/Guard Assembly Shutdown and Cleaning Flushing SprayerRemove cup and properly dispose contaminated fluid Cleaning Sprayer Exterior StorageParts Parts List Part Description QtyRemoved. See Install/Service Filter TroubleshootingInstall/Service Filter, Job or Refilling the Cup,See Charging the Battery, Spray Pattern Diagnostics See Shutdown and Cleaning, Repair Inlet ValveOutlet Valve Pressure Control Knob Pump Module/Drive Module Pump Rebuild Kit Clamshell Route wires from motor down the handle Motor/Control Board Replacement Kit Ti19632a Ti19641a Switch Assembly Install trigger lock over trigger with o-ring facing out Gear Replacement Ti19857a Ti19860a Technical Data FCC Declaration for Battery ChargerMetric 3A2308C 3A2308C Graco Standard Warranty Graco Information