Graco 16N655, 16H960, 16N927, 16N654, 16N656 Cleaning Sprayer Exterior, Storage

Page 21

Operation

Cleaning Sprayer Exterior

Wipe paint off outside of sprayer using a soft cloth moistened with water or flushing fluid. Do NOT sub- merge the sprayer or pump.

ti19400a

This sprayer is equipped with a static wick that reduces the build up of static charge to reduce the risk of fire and explosion.

KEEP THIS SURFACE

CLEAN OF OVERSPRAY.	ti19405a

Storage

1.Fill material cup 1/3 full with mineral spirits solvent or dilute a 4 oz. bottle of Pump Armor concentrate with an additional 4 oz. of water in material cup and liner.

2.Connect cup to sprayer, put prime/pressure relief valve to UP position.

3.Disengage trigger lock, turn sprayer upside-down and trigger for approximately 10 seconds to recircu- late material.

ti19374a

ti19358a

4.Reverse tip to UNCLOG position. Put prime/pres- sure relief valve DOWN to spray position and trigger sprayer through tip into waste area for 1- 2 seconds.

ti19370ati19346a

ti19366a

5.Properly dispose of used storage fluid from material cup.

6.Recharge battery to full charge before storage. See Charging the Battery, page 7.

7.Store sprayer indoors in a cool, dry place. Never store sprayer with material in the cup.

ti19347a

ti19384a

3A2308C

21

Image 21

Contents Model Protective Coating Hand-Held Paint Sprayer 3A2308CTable of Contents Grounding Instructions Skin Injection Hazard Charger Electric SHOCK, Fire and Explosion Hazard Description Component IdentificationCharging the Battery Charger Status Indicator LightsOperation Sprayer Status Indicator Common Procedures Trigger LockedTrigger Unlocked red ring is visible Adjusting Pressure Ti19655a Ti19656a Ti19654a Ti19653a Setup Starting a New JobSee Grounding Instructions, Perform Pressure Relief Procedure, Install/Service Filter if neededFilling and Installing Cup Install Tip/Guard Assembly if not installedPriming Pump Setting PressureTi19655a Ti19656a Ti19654a Ti19653a Triggering Sprayer Getting Started with Basic TechniquesAiming Sprayer Pulsating MaterialUnclogging Spray Tip/Guard Assembly Flushing Sprayer Shutdown and CleaningRemove cup and properly dispose contaminated fluid Storage Cleaning Sprayer ExteriorParts Part Description Qty Parts ListInstall/Service Filter, TroubleshootingRemoved. See Install/Service Filter Job or Refilling the Cup,See Charging the Battery, Spray Pattern Diagnostics See Shutdown and Cleaning, Inlet Valve RepairOutlet Valve Pressure Control Knob Pump Module/Drive Module Pump Rebuild Kit Clamshell Route wires from motor down the handle Motor/Control Board Replacement Kit Ti19632a Ti19641a Switch Assembly Install trigger lock over trigger with o-ring facing out Gear Replacement Ti19857a Ti19860a Technical Data FCC Declaration for Battery ChargerMetric 3A2308C 3A2308C Graco Information Graco Standard Warranty