Remove cup and properly dispose contaminated fluid

7.Disengage trigger lock, turn sprayer upside-down and trigger for approximately 15 seconds to recirculate material.

Operation

11.Remove cup and properly dispose contaminated fluid.

ti19374a

To avoid serious injury or damage to equipment, do not expose the sprayer electronics to flushing solvents. Keep sprayer at least 10 in. above the rim of the con- tainer when flushing.

ti19798a

Keep spray area well-ventilated. Keep a good supply of fresh air moving through the area. When flushing with solvents, always ground the sprayer and waste container.

8.Reverse tip to UNCLOG position. Put prime/pres- sure relief valve DOWN to spray position and trigger sprayer through tip into waste area for 1- 2 seconds.

ti19370a ti19346a ti14995a

ti19366a

9.Engage trigger lock. Put prime/pressure relief valve in UP position.

ti19350ati19347a

10.Unthread tip/guard from sprayer and soak in appro- priate flushing fluid.

ti19386a

ti19385a

12.Refill liner 1/2 full. Disengage trigger lock, turn sprayer upside-down and trigger sprayer for approximately 15 seconds to recirculate material.

ti19374a

ti19358a

13.Put prime/pressure relief valve DOWN to spray position. Spray the remaining amount of cleaning fluid through the front of the sprayer.

ti19346a	ti19404a

14.If sprayer is not completely clean, repeat steps 11 and 12.

15.Engage trigger lock and put prime/pressure relief valve UP to release pressure.

ti19350a	ti19347a

16.Remove material liner and lid and properly dispose. Properly dispose used fluid.

ti19385a

17.Clean Spray Tip/Guard assembly with clean flush- ing fluid. Use a soft brush to loosen and remove dried material if needed.

ti19344a

3A2308C