Graco 16N656, 16H960, 16N655, 16N927, 16N654 important safety instructions Gear Replacement

Page 39

Repair

Gear Replacement

4. Remove four screws holding clamshells together and two bolts connecting drive to clamshell.

Removal

1.Remove pump module from drive module. See Pump Module/Drive Module, page 31.

ti19625a

2.If unit has accessible retaining bolt shown below, proceed to step 3. If unit does not have accessible retaining bolt, proceed to step 4.

ti19858a

3.Unscrew retaining bolt until gear (48) is no longer retained. Remove gear from drive. Proceed to Installation.

ti19859a

48

ti19860a

ti19877ati19861a

5.Pull the clamshell up and unscrew retaining bolt until gear (48) is no longer retained. Remove gear from drive. Proceed to Installation.

ti19878a

48

ti19860a

Installation

1. Engage trigger lock and remove battery from unit.

ti19350a

ti19617a

3A2308C

39

Image 39

Contents Model Protective Coating Hand-Held Paint Sprayer 3A2308CTable of Contents Grounding Instructions Skin Injection Hazard Charger Electric SHOCK, Fire and Explosion Hazard Description Component IdentificationCharging the Battery Charger Status Indicator LightsOperation Sprayer Status Indicator Common Procedures Trigger LockedTrigger Unlocked red ring is visible Adjusting Pressure Ti19655a Ti19656a Ti19654a Ti19653a Setup Starting a New JobSee Grounding Instructions, Perform Pressure Relief Procedure, Install/Service Filter if neededFilling and Installing Cup Install Tip/Guard Assembly if not installedPriming Pump Setting PressureTi19655a Ti19656a Ti19654a Ti19653a Pulsating Material Getting Started with Basic TechniquesTriggering Sprayer Aiming SprayerUnclogging Spray Tip/Guard Assembly Flushing Sprayer Shutdown and CleaningRemove cup and properly dispose contaminated fluid Storage Cleaning Sprayer ExteriorParts Part Description Qty Parts ListJob or Refilling the Cup, TroubleshootingInstall/Service Filter, Removed. See Install/Service FilterSee Charging the Battery, Spray Pattern Diagnostics See Shutdown and Cleaning, Inlet Valve RepairOutlet Valve Pressure Control Knob Pump Module/Drive Module Pump Rebuild Kit Clamshell Route wires from motor down the handle Motor/Control Board Replacement Kit Ti19632a Ti19641a Switch Assembly Install trigger lock over trigger with o-ring facing out Gear Replacement Ti19857a Ti19860a Technical Data FCC Declaration for Battery ChargerMetric 3A2308C 3A2308C Graco Information Graco Standard Warranty